Ethanol → 1-(2-Fluorophenyl)-2-methoxynaphthalene

Participants

Reaction Steps

Into a 500 mL three-neck flask were placed 8.7 g (35 mmol) of 1-bromo-2-methoxynaphthalene, and 5.0 g (35 mmol) of 2-fluorophenylboronic acid. The air in the flask was replaced with nitrogen. To this mixture were added 120 mL of toluene, 60 mL of ethanol, and 40 mL of an aqueous solution of sodium carbonate (2.0 mol/L). While the pressure was reduced; this mixture was stirred to be degassed. To this mixture was added 2.0 g (1.7 mmol) of tetrakis(triphenylphosphine)palladium(0), and the mixture was stirred at 80° C. for 8 hours under a nitrogen stream. The aqueous layer of the obtained mixture was subjected to extraction with toluene, and the obtained solution of the extract and the organic layer were combined and washed with saturated brine. The organic layer was dried over magnesium sulfate, and this mixture was gravity-filtered. An oily substance obtained by concentration of the obtained filtrate was dissolved in about 30 mL of toluene. This solution was suction-filtered through Celite (produced by Wako Pure Chemical Industries, Ltd., Catalog No. 531-16855), alumina, and Florisil (produced by Wako Pure Chemical Industries, Ltd., Catalog No. 540-00135). An oily substance obtained by concentration of the obtained filtrate was dried under reduced pressure, so that 5.3 g of a pale yellow oily substance of the object of the synthesis was obtained in 60% yield. The above-described synthesis scheme is illustrated in the following scheme (C-1).

Provenance & Evidence