Hydrochloric Acid → HCID 58461093, compound

Participants

Reaction Conditions

Reaction Steps

First, 5.0 g of 2,6-dibromonaphthalene was placed into a 500-mL three-neck flask, and the air in the flask was replaced with nitrogen. To this compound was added 200 mL of tetrahydrofuran (THF), and this solution was stirred at −78° C. for 20 minutes. Then, 12 mL of a 1.7M hexane solution of n-butyllithium (n-BuLi) was dripped into this mixture solution, followed by stirring at −78° C. for 2 hours. After the predetermined time had elapsed, 3.5 mL of trimethyl borate was added to the mixture and this solution was stirred for 18 hours while the temperature was raised to room temperature. After the predetermined time had elapsed, 80 mL of 1.0M hydrochloric acid was poured into this solution, and the mixture was stirred for 1 hour. Then, the mixture solution was separated into an organic layer and an aqueous layer. Organic substances were extracted with ethyl acetate from the obtained aqueous layer. The solution of the extract was combined with the organic layer that had been first obtained, and the mixture was washed with saturated brine and dried by addition of anhydrous magnesium sulfate. Then, the filtrate obtained by gravity filtration was concentrated to give a white solid. The obtained white solid was washed with ethanol, whereby 6-bromonaphthalene-2-boronic acid was obtained (as a white powder in 35% yield). The synthesis scheme of Step 1 is illustrated in the following (a-4).

Provenance & Evidence