Sodium Carbonate → 4,6-diphenylpyrimidine

Participants

Reaction Steps

First, into a recovery flask equipped with a reflux pipe, 5.02 g of 4,6-dichloropyrimidine, 8.29 g of phenylboronic acid, 7.19 g of sodium carbonate, 0.29 g of bis(triphenylphosphine)palladium(II)dichloride (abbreviation: Pd(PPh3)2Cl2), 20 mL of water, and 20 mL of acetonitrile were put, and the air in the flask was replaced with argon. This reaction container was subjected to irradiation with microwaves (2.45 GHz, 100 W) for one hour to be heated. Here, into the flask, 2.08 g of phenylboronic acid, 1.79 g of sodium carbonate, 0.070 g of Pd(PPh3)2Cl2, 5 mL of water, and 5 mL of acetonitrile were further put, and the reaction container was heated again by irradiation with microwaves (2.45 GHz, 100 W) for one hour. Then, water was added to this solution and an organic layer was extracted with dichloromethane. The obtained extract was washed with water, dried with magnesium sulfate, and then filtered. The solvent of the filtrate was distilled off, and then the obtained residue was purified by silica gel column chromatography using dichloromethane as a developing solvent. As a result, a pyrimidine derivative Hdppm (yellow white powder, yield of 38%) was obtained. Note that the irradiation with microwaves was performed using a microwave synthesis system (Discover, produced by CEM Corporation). A synthesis scheme (a-1) of Step 1 is shown below.

Provenance & Evidence