Sodium Carbonate → 4-Methyl-6-phenylpyrimidine

Participants

Reaction Steps

Into a recovery flask equipped with a reflux pipe, 4.90 g of 4-chloro-6-methylpyrimidine, 4.80 g of phenylboronic acid, 4.03 g of sodium carbonate, 0.16 g of bis(triphenylphosphine)palladium(II)dichloride (abbreviation: Pd(PPh3)2Cl2), 20 mL of water, and 10 mL of acetonitrile were put, and the air in the flask was replaced with argon. This reaction container was subjected to irradiation with microwaves (2.45 GHz, 100 W) for one hour to be heated. Here, into the flask, 2.28 g of phenylboronic acid, 2.02 g of sodium carbonate, 0.082 g of Pd(PPh3)2Cl2, 5 mL of water, and 10 mL of acetonitrile were further put, and the reaction container was heated again by irradiation with microwaves (2.45 GHz, 100 W) for one hour. After that, water was added to this solution and extraction with dichloromethane was carried out. The obtained solution of the extract was washed with a saturated aqueous solution of sodium carbonate, water, and then with saturated saline, dried with magnesium sulfate, and filtered. The solvent of the filtrate was distilled off, and then the obtained residue was purified by silica gel column chromatography using dichloromethane and ethyl acetate as a developing solvent in a volume ratio of 9:1, so that a pyrimidine derivative Hmppm, which was the objective substance, was obtained (orange oily substance, yield of 46%). Note that the irradiation with microwaves was performed using a microwave synthesis system (Discover, produced by CEM Corporation). A synthesis scheme (b-1) of Step 1 is shown below.

Provenance & Evidence