Potassium Carbonate → 9-Phenyl-9H,9'H-[3,3']bicarbazolyl

Participants

Reaction Steps

2.5 g of (10 mmol) 3-bromo-9H-carbazole, 2.9 g of (10 mmol) N-phenylcarbazol-3-boronic acid, and 152 mg of (0.50 mmol) tri(ortho-tolyl)phosphine were put into a 200 mL three-neck flask. The air in the flask was replaced with nitrogen. To the mixture were added 50 mL of dimethoxyethanol and 10 mL of an aqueous solution of potassium carbonate (2 mol/L). This mixture was stirred to be degassed while the pressure was reduced. After the degassing, 50 mg (0.2 mmol) of palladium acetate was added to the mixture. This mixture was stirred at 80° C. for 3 hours under a stream of nitrogen. After the stirring, about 50 mL of toluene was added to this mixture. The mixture was stirred for about 30 minutes and then washed with water and a saturated saline solution in this order. After the washing, an organic layer was dried with magnesium sulfate. This mixture was subjected to gravity filtration. The obtained filtrate was condensed to give an oily substance. The obtained oily substance was dissolved in toluene. This solution was subjected to suction filtration through Florisil (produced by Wako Pure Chemical Industries, Ltd., Catalog No. 540-00135), alumina, and celite (produced by Wako Pure Chemical Industries, Ltd., Catalog No. 531-16855). The obtained filtrate was concentrated to give 3.3 g of a white solid, which was the object of the synthesis, at a yield of 80%. A synthesis scheme of Step 1 is shown in (b-1) given below.

Provenance & Evidence