Octylamine → Benzenemethanesulfonamide

Participants

Reaction Steps

The synthesis of the sulfonamide containing carboxylic acid precursor corresponding to the autoinducer analog 10 was accomplished by the two step sequence described below. Accordingly, a solution of α-toluenesulfonyl chloride (10 mmol) in CH2Cl2 (5 mL) was added dropwise to a stirred solution of octylamine (20 mmol) in CH2Cl2 (20 mL) at 0° C. The resulting mixture was subsequently stirred at room temperature for 30 min and was then extracted with H2O (3×24 mL) The organic phase was dried (MgSO4) and the solvent was evaporated in vacuo to provide the corresponding α-toluenesulfonamide (262 mg, 93%) as a colorless solid. Subsequent oxidative degradation of the phenyl moiety within this compound via the procedure of Sharpless, et al. [e.g., cat. RuCl3 hydrate, NaIO4, H2O/CH3CN/CCl4 (vide supra)] furnished the α-sulfonamidoacetic acid corresponding to homoserine lactone 10. Accordingly, a mixture of the above a-toluenesulfonamide (1.00 mmol), CCl4 (2 mL), CH3CN (2 mL), H2O (3 mL) and NaIO4 (14.50 mmol) was vigorously stirred at room temperature and RuCl3 hydrate (5 mg) was added. The reaction mixture was vigorously stirred for a further 2 h at room temperature and then CH2Cl2 (10 mL) was added and the phases were separated. The upper aqueous phase was extracted with three portions of CH2Cl2 and the combined organic phases were dried (MgSO4) and the solvents were removed in vacuo. Recrystallization of the residue from EtOH provided the α-sulfonamidoacetic acid (181 mg, 72%) as a colorless solid.

Provenance & Evidence