Nitrogen → 5-Bromo-2-(4-fluorophenyl)furo[2,3-b]pyridine

Participants

Reaction Conditions

Reaction Steps

5-bromo-3-iodopyridin-2-ol (6.7 g, 22 mmol) (Heterocycles. 57, 1, pp 55), 1-ethynyl-4-fluorobenzene (4.03 g, 33.5 mmol), copper(I) iodide (0.255 g, 1.34 mmol), trans-dichlorobis(triphenylphosphine)palladium (II) (0.784 g, 1.12 mmol) were combined and evacuated/backfilled with N2 (3×) then diluted with triethylamine (223 mL) and heated to 90° C. for 2 hours. The solvent was evaporated and the residue was dissolved in EtOAc. The organic phase was washed with water (50 mL), brine, dried over Na2SO4, filtered, and concentrated. Trituration with Et2O afforded the expected product 5-bromo-2-(4-fluorophenyl)furo[2,3-b]pyridine (4.2 g, 14.4 mmol, 64% yield). 1H NMR (400 MHz, DMSO-d6) δ ppm 8.35-8.42 (2H, m), 8.03 (2H, dd, J=8.78, 5.27 Hz), 7.46 (1H, s), 7.39 (2H, t, J=8.91 Hz). LC-MS retention time: 2.36 min; m/z (MH+): 292, 294. LC data was recorded on a Shimadzu LC-10AS liquid chromatograph equipped with a Waters SunFire 5u C18 4.6×50 mm column using a SPD-10AV UV-Vis detector at a detector wave length of 220 nM. The elution conditions employed a flow rate of 5 ml/min, a gradient of 100% solvent A/0% solvent B to 0% solvent A/100% solvent B, a gradient time of 2 min, a hold time of 1 min, and an analysis time of 3 min where solvent A was 10% acetonitrile/90% H2O/0.1% trifluoroacetic acid and solvent B was 10% H2O/90% acetonitrile/0.1% trifluoroacetic acid. MS data was determined using a Micromass Platform for LC in electrospray mode.

Provenance & Evidence