HRID480933

反应详情

EQUATION

反应方程式

HRID 480933 的结构方程式

AUXILIARIES

试剂、催化剂与溶剂

1

CONDITIONS

反应条件

温度
0 °C

PROCEDURE

实验过程

Commercially available 4-formylbenzoic acid (5.0 g, 33.3 mmol) was dissolved in a mixture of anhydrous tetrahydrofuran (100 ml) and anhydrous N,N-dimethylformamide (1 ml) and the mixture was cooled with stirring to 0° C. To the resulting mixture was added dropwise oxalyl chloride (3.8 ml, 43.3 mmol). The mixture was stirred at room temperature for 30 minutes and then at 40° C. for 20 minutes. The reaction mixture was concentrated under reduced pressure and then in vacuo to afford 4-formylbenzoyl chloride. 4-(2,2,3,3-Tetrafluoropropoxy)aniline (646 mg, 2.9 mmol), described in Chem. Pharm. Bull., 44 (2), 314 (1996), and N,N-diisopropylethylamine (1.21 ml, 7.0 mmol) were dissolved in anhydrous tetrahydrofuran (8 ml) and the mixture was cooled to 0° C. with stirring. To the resulting mixture was added dropwise a solution of 4-formylbenzoyl chloride (561 mg, 3.33 mmol) obtained above in anhydrous tetrahydrofuran (2 ml). This mixture was stirred at room temperature for 17 hours and then at 40° C. for 20 minutes. At the end of this time, saturated aqueous sodium hydrogencarbonate solution was added to the reaction mixture in an ice bath and the mixture was partitioned between ethyl acetate and water. The organic layer was washed sequentially with 0.5N hydrochloric acid, saturated aqueous sodium hydrogencarbonate solution, water, and saturated aqueous sodium chloride solution, dried over anhydrous magnesium sulfate and concentrated under reduced pressure. The crystalline residue was recrystallized from a mixture of ethyl acetate and hexane to give 4-formyl-4′-(2,2,3,3-tetrafluoropropoxy)benzanilide (634 mg, yield 62%) as pale yellow crystals.

WORKUP

后处理

  1. stirringThis mixture was stirred at room temperature for 17 hours
  2. customthe mixture was partitioned between ethyl acetate and water
  3. washThe organic layer was washed sequentially with 0.5N hydrochloric acid, saturated aqueous sodium hydrogencarbonate solution, water, and saturated aqueous sodium chloride solution
  4. dry with materialdried over anhydrous magnesium sulfate
  5. concentrationconcentrated under reduced pressure
  6. customThe crystalline residue was recrystallized from a mixture of ethyl acetate and hexane