反应详情

温度

120 °C

In a 100-mL three-neck flask were put 0.74 g (1.6 mmol) of 5,6-bis(4-bromophenyl)-2,2′-bipyridine, 1.1 g (3.7 mmol) of 10-phenylanthracene-9-boronic acid, 0.79 g (7.4 mmol) of sodium carbonate, 20 mL of toluene, 5 mL of ethanol, and 5 mL of water. The mixture was degassed by being stirred under reduced pressure, and the air in the flask was replaced with nitrogen. To this mixture was added 74 mg (0.14 mmol) of tetrakis(triphenylphosphine)palladium(0), and the mixture was refluxed at 120° C. under a nitrogen stream for ten hours. After a predetermined time, water was added to this mixture to separate an aqueous layer and an organic layer, and then an organic substance was extracted with toluene from the aqueous layer. The obtained extracted solution and the organic layer were combined and washed with saturated saline, the aqueous layer and the organic layer are separated, and the organic layer was dried with magnesium sulfate. The mixture was gravity filtered, and the obtained filtrate was concentrated to give an oily substance. The obtained oily substance was purified by silica gel column chromatography (toluene), so that a solid was obtained. A methanol suspension of the obtained solid was irradiated with ultrasonic waves, and a solid was collected by suction filtration. The obtained solid was recrystallized with toluene to give 0.56 g of light yellow powder, which was the objective substance, in a yield of 43%. The synthesis scheme of this reaction is shown below.

1. customIn a 100-mL three-neck flask were put
2. customThe mixture was degassed
3. customto separate an aqueous layer
4. extractionan organic layer, and then an organic substance was extracted with toluene from the aqueous layer
5. extractionThe obtained extracted solution
6. washwashed with saturated saline
7. customthe aqueous layer and the organic layer are separated
8. dry with materialthe organic layer was dried with magnesium sulfate
9. filtrationfiltered
10. concentrationthe obtained filtrate was concentrated
11. customto give an oily substance
12. customThe obtained oily substance was purified by silica gel column chromatography (toluene), so that a solid
13. customwas obtained
14. customwas irradiated with ultrasonic waves
15. filtrationa solid was collected by suction filtration
16. customThe obtained solid was recrystallized with toluene