Sodium hydride → HCID 67485792, compound

Participants

Reaction Conditions

Reaction Steps

To 600 ml of DMF in a 4 neck 3000 mL round bottom flask equipped with an overhead stir mechanism under nitrogen was added 2-methylpyridin-3-ol (71.8 g, 658 mmol) and the reaction was cooled to 2° C. Sodium hydride (60%, 26.3 g, 658 mmol) was added over a period of 30 minutes at a rate such that the internal temperature did not exceed 10° C. The reaction was stirred while warming to ambient temperature for 1 hour. 5-Bromo-3-nitropicolinonitrile (150 g, 658 mmol) in a solution of 400 mL of DMF was added in two portions and the reaction held at ambient temperature for 1.5 hour. To the reaction at ambient temperature was added pyridine-2-thiol (73.1 g, 658 mmol) as a solid in portions and the reaction was stirred for 15 minutes to dissolve the material. The reaction was cooled to 3° C. and sodium hydride (26.3 g, 658 mmol) again was added in portions over 35 minutes such that the internal temperature did not go above 10° C. The reaction was removed from the ice bath and warmed to ambient temperature while stirring for 12 hours. The reaction was diluted with 4 volumes (8 L) of brine and stirred for 30 minutes, at which point solid formed. The solid was filtered off and the filtrate was extracted with MTBE (10 L total). The MTBE phase was concentrated in vacuo. The solid was combined with concentrated material and dissolved in ethyl acetate (3 L). The EtOAc was washed with brine (4×1 L), dried over MgSO4, filtered and concentrated in vacuo. The solid that formed was ground into a powder and dried in vacuo for 4 hours. The material was taken up in 30 mL of MTBE/10 g of product and the reaction was stirred for 30 minutes. The solid was filtered and dried in vacuo (2 hours). The mother liquor was concentrated and triturated with MTBE (same dilution rate). The solids were combined and dried for 3 hours in vacuo to yield 3-(2-methylpyridin-3-yloxy)-5-(pyridin-2-ylthio)picolinonitrile (181 g, 85%).

Provenance & Evidence