Sodium Carbonate → HCID 67286040, compound

Participants

Reaction Steps

First, into a recovery flask equipped with a reflux pipe were put 4.99 g of 4,6-dichloropyrimidine, 9.23 g of 3-methylphenylboronic acid, 7.18 g of sodium carbonate, 0.29 g of bis(triphenylphosphine)palladium(II)dichloride (abbreviation: Pd(PPh3)2Cl2), 20 mL of water, and 20 mL of acetonitrile, and the air in the flask was replaced with argon. This reaction container was heated by irradiation with microwaves (2.45 GHz, 100 W) for 60 minutes. Here, into the flask were further put 2.31 g of 3-methylphenylboronic acid, 1.82 g of sodium carbonate, 0.070 g of Pd(PPh3)2Cl2, 5 mL of water, and 5 mL of acetonitrile, and the mixture was heated again by irradiation with microwaves (2.45 GHz, 100 W) for 60 minutes. After that, water was added to this solution and an organic layer was extracted with dichloromethane. The obtained organic layer was washed with saturated aqueous solution of sodium hydrogen carbonate, water, and saturated saline, and was dried with magnesium sulfate. The solution after drying was filtered. The solvent of this solution was distilled off, and then the obtained residue was purified by silica gel column chromatography using dichloromethane and ethyl acetate as a developing solvent in a ratio of 20:1, so that a pyrimidine derivative H5mdppm, which was the objective substance, was obtained (pale yellow powder, yield of 15%). Note that the irradiation with microwaves was performed using a microwave synthesis system (Discover, manufactured by CEM Corporation). A synthesis scheme (n−1) of Step 1 is shown below.

Provenance & Evidence