Methanol → Quinacridone

Participants

Reaction Conditions

Reaction Steps

To 240 g of polyphosphoric acid (116% phosphoric acid) heated at 85° C. was added 0.15 g of Carbazole Violet followed by 60 g of 2,5-dianilinoterephthalic acid. The mixture was heated at 120°-125° C. for two hours. After the melt was cooled to 95° C., the acid strength was adjusted to 110% by the dropwise addition of phosphoric acid. The resultant melt was stirred for 15 minutes and then slowly poured into 400 g of methanol at 24° C. During the drown, the temperature was allowed to increase to 60° C., with the temperature being controlled by external cooling and adjustment of melt addition rate. The slurry was heated at reflux (68°-72° C.) for one hour, diluted with water, and stirred at 60° C. for 30 minutes. The solid component was collected by filtration and washed with water until acid free. The resultant presscake was reslurried in water. After adjustment of the pH to greater than 7, 5 g of 50% sodium hydroxide was added and the resultant slurry was heated at 90° C. for two hours. The slurry was cooled, filtered, and washed with water until alkali free, then reslurried in water. After adjustment of the pH to greater than 9.0-9.5, 3.2 g of a cycloaliphatic carboxylic acid was added. The resultant slurry was heated at about 140°-145° C. for four hours in a closed system, cooled to less than 45° C., acidified with phosphoric acid, and stirred. The solid component was collected by filtration and washed with water. The wet cake can be dried or used as is for specific applications. Here, the wet cake was dried in an oven at 60° C. to give approximately 50 g of quinacridone as a violet pigment.

Provenance & Evidence