Sodium Carbonate → 4-Methyl-6-phenylpyrimidine

Participants

Reaction Steps

First, 4.90 g of 4-chloro-6-methylpyrimidine, 4.80 g of phenylboronic acid, 4.03 g of sodium carbonate, 0.16 g of bis(triphenylphosphine)palladium(II)dichloride (abbreviation: Pd(PPh3)2Cl2), 20 mL of water, and 10 mL of acetonitrile were put into a recovery flask equipped with a reflux pipe, and the air in the flask was replaced with argon. This reaction container was heated by irradiation with microwaves (2.45 GHz, 100 W) for 60 minutes. Here, there were further put 2.28 g of phenylboronic acid, 2.02 g of sodium carbonate, 0.082 g of Pd(PPh3)2Cl2, 5 mL of water, and 10 mL of acetonitrile in the flask, and the mixture was heated again by irradiation with microwaves (2.45 GHz, 100 W) for 60 minutes. After that, water was added to this solution and extraction with dichloromethane was carried out. The obtained solution of the extract was washed with a saturated aqueous solution of sodium carbonate, water, and then with saturated saline, and dried with magnesium sulfate. The solution after drying was filtered. The solvent of this solution was distilled off, and then the obtained residue was purified by silica gel column chromatography using dichloromethane and ethyl acetate as a developing solvent in a volume ratio of 9:1, so that the objective pyrimidine derivative Hmppm (orange oily substance, yield of 46%) was obtained. Note that the irradiation with microwaves was performed using a microwave synthesis system (Discover, manufactured by CEM Corporation). A synthesis scheme (b-1) of Step 1 is shown below.

Provenance & Evidence