Acetic Acid → Tetraethyl orthocarbonate

Participants

Reaction Conditions

Reaction Steps

The keto-ester was prepared by the sodium hydride induced acylation of cyclooctanone (1 using diethyl carbonate). A 1-L round bottom flask was charged with NaH (60% dispersion in mineral oil, 17.0 g, 708 mmol). The NaH was washed with three portions of toluene (200 mL), diethyl carbonate (36 mL, 207 mmol) was charged to the flask, and the reaction mixture warmed to 80° C. A solution of cyclooctanone (18.76 g, 149 mmol) in toluene (50 mL) was added dropwise over 1 hr. The temperature was maintained at 80° C. for 1.5 hr after the addition of cyclooctanone. Upon cooling to room temperature, glacial acetic acid (30 mL) was added dropwise, followed by ice water (200 mL). The reaction mixture was stirred until all the solid was in solution (additional water may be necessary). The layers were separated, and the aqueous layer was extracted with toluene (3×100 mL). The organic layer was dried over MgSO4, filtered, and evaporated in vacuo to yield an oil. Purification was achieved by simple high vacuum distillation (91°-93° C. 0.5 to 0.6 mmHg) to yield 20.8 g, 71% of 6; IR (neat) 2950, 2870, 1745, 1710, 1640, 1617, 1468, 1382, 1330, 1250, 1230, 1185, 1100 cm−1; 1H NMR (CDCl3, 300 MHz) δ(keto-enol mix) 1.23 (t), 1.29 (t), 1.33 to 1.58 (m), 1.62 to 1.76 (m), 1.85 to 1.95 (m), 2.32 to 2.68 (m), 3.5 to 3.6 (m), 4.1 to 4.25 (m), 12.6 (s, enol H).

Provenance & Evidence