StartseiteMCPWorkbenchSkills
StartseiteWorkbenchBenachrichtigungenMein Bereich
llms.txt · MCP-AnleitungDatenschutz · Nutzungsbedingungen · Supportv1.8.1
  1. Startseite
  2. /Reaktion

Carbon Tetrachloride → Neoheptanoyl chloride

HRID 1045269
Drucken

Reaktionsgleichung

Reaktionsgleichung von HRID 1045269
C1C=CC(P(C2C=CC=CC=2)C2C=CC=CC=2)=CC=1.[C:20]([OH:28])(=O)[CH2:21][CH2:22][C:23]([CH3:26])([CH3:25])[CH3:24].CC(C)(CCC)C(O)=O.C(C(C)(CC)C(O)=O)C.CC(C)(C(C)C)C(O)=O.P.C(Cl)(Cl)(Cl)[Cl:58]>O>[C:20]([Cl:58])(=[O:28])[CH2:21][CH2:22][C:23]([CH3:26])([CH3:25])[CH3:24]
KomponentenReaktionsbedingungenVersuchsvorschriftAufarbeitungQuellen und NachweiseNotizen zur Reaktion

Komponenten

9

Edukt 7

HCID 5943Carbon Tetrachloride2×HCID 11776TriphenylphosphineHCID 142374,4-Dimethylpentanoic acidHCID 144552,2-Dimethylpentanoic acidHCID 24404PhosphineHCID 298462-Ethyl-2-methylbutyric acidHCID 639797
2,2,3-Trimethylbutyric acid

Produkt 1

HCID 14921487Neoheptanoyl chloride

Reagenzien, Katalysatoren, Lösungsmittel 1

HCID 962WaterLösungsmittel

Reaktionsbedingungen

Temperatur
80 °C

Versuchsvorschrift

A 604.45 g (2.3 mol, 1 eq.) portion of PPh3 was dissolved in 724 mL CCl4 in a 2 L three-necked round-bottom flask under N2 to give a hazy solution. A stirbar was added and the flask was fitted with a water-cooled condenser topped with a N2 inlet/outlet, mechanical stirrer and shaft, and an addition funnel. The addition funnel was charged with a solution of ExxonMobil Neoheptanoic Acid Prime (300 g, 2.30 mol uncorrected for purity) in 300 mL CCl4. This material was 94.1% purity with an isomer balance of 43.0% 2,2-dimethylpentanoic acid (DMPA), 37.6% 2-ethyl-2-methylbutanoic acid (EMBA), and 13.5% 2,2,3-trimethylbutanoic acid (TMBA) by GC analysis (using FID detection; uncorrected for response factor). The acid solution was added dropwise at room temperature while stirring over a 1 hour period. No immediate reaction was observed other than a decrease in haziness to give a clear solution. After stirring under N2 for an additional hour at room temperature, the addition funnel was removed and the contents of the flask were heated at reflux (˜80° C.) for 3 h. The formation of a white precipitate was observed upon heating. Subsequently, the mixture was cooled to room temperature and filtered. Solvent was removed from the filtrate using a rotary evaporator. The residue was cooled in a refrigerator for 24 h and subsequently crushed with a spatula and extracted with 800 mL hexane for 2 hours. Solids were removed by filtration and the hexane filtrate depleted of volatiles using a rotary evaporator and high vacuum (at 50° C.) to give 200 g of a crude material containing product, phosphine-containing residues, unreacted acid, and other species (most likely neoheptanoic anhydrides). Fractional distillation of the crude material gave neoheptanoic acid chloride as the first boiling fraction (50° C./2.4×10−2 torr; 57.4 g, 17%); higher boiling fractions contained species assigned as neoheptanoic anhydrides (13C NMR C═O 173.1-173.0 ppm; IR υC═O 1808 and 1741 cm−1) and free acids. Elemental analysis calc. for C17H13ClO: C, 56.57; H, 8.82; Cl, 23.85; O, 10.76. Found: C, 56.64; H, 8.96; Cl, 23.60. 1H NMR (CDCl3, 400 MHz): δ 2.17 (septet, J=6.9 Hz, CHMe2 of TMBA), 1.81 (app. sextet, J=7.3 Hz), 1.64-1.53 (m), and 1.35-1.29 (m) (probably CH2 groups of EMBA and DMPA), 1.28 (s, probably CMe2 of DMPA), 1.21 and 1.20 (2 singlets, probably CMeEt of EMBA and CMe2 of TMBA), 0.94-0.88 (m, CHMe2 of TMBA, CH2Me of EMBA, and CH2Me of DMPA). 13C NMR (CDCl3, 125 MHz): δ 180.53 (C═O of TMBA), 180.11 (C═O of DMPA), 179.75 (C═O of EMBA), 57.23 (CMeEt of EMBA), 56.17 (CMe2 of TMBA), 52.84 (CMe2 of DMPA), 42.55 (CH2 of DMPA), 34.34 (CHMe2 of TMBA), 31.41 (CH2 of EMBA), 25.11 (CMe2 of DMPA), 21.46 (CMe2 of TMBA), 20.38 (CMeEt of EMBA), 17.93 (CH2Me of DMPA), 17.22 (CHMe2 of TMBA), 14.32 (CH2Me of DMPA), 8.58 (CH2Me of EMBA). Isomer ratio (average of C═O and CR2 resonances): 12.6% TMBA, 42.1% EMBA, 45.4% DMPA. IR (NaCl disk): 2970 (s), 2940 (sh), 2877 (sh), 1789 (vs, υC═O), 1698 (m, may be acid υC═O from incidental hydrolysis), 1460 (m), 1387 (w), 1369 (sh), 1194 (w), 1066 (w), 1009 (w), 975 (w), 961 (w), 916 (vs), 888 (m), 864 (m), 804 (vs), 756 (w), 743 (w) cm1.

Aufarbeitung

  1. customto give a hazy solution
  2. additionA stirbar was added
  3. temperaturecooled condenser
  4. customtopped with a N2 inlet/outlet, mechanical stirrer
  5. additionThe acid solution was added dropwise at room temperature
  6. customNo immediate reaction
  7. customto give a clear solution
  8. stirringAfter stirring under N2 for an additional hour at room temperature
  9. customthe addition funnel was removed
  10. temperaturethe contents of the flask were heated
  11. temperatureupon heating
  12. temperatureSubsequently, the mixture was cooled to room temperature
  13. filtrationfiltered
  14. customSolvent was removed from the filtrate
  15. customa rotary evaporator
  16. temperatureThe residue was cooled in a refrigerator for 24 h
  17. customsubsequently crushed with a spatula
  18. extractionextracted with 800 mL hexane for 2 hours
  19. customSolids were removed by filtration
  20. customa rotary evaporator and high vacuum (at 50° C.)
  21. customto give 200 g of a crude material
  22. distillationFractional distillation of the crude material

Quellen und Nachweise

ORD-Eintrag
ord-0ff1cd88f9744dd69972581a62d97458
Quelldatensatz
uspto-grants-2013_10
DOI
10.6084/m9.figshare.5104873.v1
Patentnummer
US08568846B2

Notizen zur Reaktion

Auf dieser SeiteKomponentenReaktionsbedingungenVersuchsvorschriftAufarbeitungQuellen und NachweiseNotizen zur Reaktion