StartseiteMCPWorkbenchSkills
StartseiteWorkbenchBenachrichtigungenMein Bereich
llms.txt · MCP-AnleitungDatenschutz · Nutzungsbedingungen · Supportv1.8.3
  1. Startseite
  2. /Reaktion

Toluene → 5-Butyl-4-methyldihydro-2(3H)-furanone, trans-

HRID 1587109
Drucken

Reaktionsgleichung

Reaktionsgleichung von HRID 1587109
[CH2:1]([Li])[CH2:2][CH3:3].S(C1C=CC(C)=CC=1)([O-])(=O)=[O:6].[C:16]1([CH3:22])[CH:21]=[CH:20]C=CC=1.[Cl-].[NH4+].CC[O:27][CH2:28][CH3:29]>[Cu](I)I>[CH3:3][C@@H:2]1[C@@H:1]([CH2:22][CH2:16][CH2:21][CH3:20])[O:6][C:28](=[O:27])[CH2:29]1
KomponentenReaktionsbedingungenVersuchsvorschriftAufarbeitungQuellen und NachweiseNotizen zur Reaktion

Komponenten

7

Edukt 5

HCID 1140TolueneHCID 3283Diethyl Ether2×HCID 25517Ammonium ChlorideHCID 85570p-ToluenesulfonateHCID 178506857HCID 178506857, Verbindung

Produkt 1

HCID 110841235-Butyl-4-methyldihydro-2(3H)-furanone, trans-Ausbeute 70,6 %

Reagenzien, Katalysatoren, Lösungsmittel 1

HCID 83717Copper iodideKatalysator

Reaktionsbedingungen

Temperatur
-50 °C

Versuchsvorschrift

In 20 ml of anhydrous ether, 1.98 g of copper iodide (10.4 mmol) were suspended. To the obtained suspension, 20.8 ml of n-propyl lithium solution (1.0 N, 20.8 mmol) were added dropwise under an argon atmosphere with cooling at -50° C. Next, the resultant suspension was added dropwise into a mixture solution of 10 ml of anhydrous ether in which 1.97 g of tosylate (6.93 mmol) obtained in step [C] were dissolved, and 10 ml of toluene, under an argon atmosphere at -60° C. Next, the temperature of the reacted solution was raised from -60° C. to -20° C. over three hours. After that, the reacted solution was poured into a saturated aqueous ammonium chloride solution, then the obtained solution was stirred for thirty minutes, and filtered to remove insoluble substances. The obtained filtrate was extracted with ether, and the resultant extract was washed with water and a saturated aqueous sodium chloride solution, in this order. The resultant extract was then dried with anhydrous magnesium sulfate, and filtered. The filtrate was then concentrated. The obtained residue was dissolved in 20 ml of methanol, and 20 ml of 10% sodium hydroxide were added, and the solution was stirred at room temperature for three hours. After that, the methanol in the solution was distilled off under reduced pressure, the obtained residue was extracted twice with diethyl ether, and then the organic layer was separated from the obtained extract. Also, the residual aqueous layer was acidified with dilute hydrochloric acid, and extracted with diethyl ether five times. The obtained extract was combined with the organic layer as obtained before. The combined organic layer was dried with anhydrous magnesium sulfate, and concentrated to obtain the crude product. This crude product was purified via silica gel column chromatogrpahy (n-hexane:ether=10:1 to 2.1) and distilled under reduced pressure to obtain 763 mg of (3S,4R)-3-methyl-4-octanolide (trans-whisky lactone) (yield: 70.6%). This product exhibited the following properties:

Aufarbeitung

  1. dissolutionwere dissolved
  2. customat -60° C
  3. temperatureNext, the temperature of the reacted solution was raised from -60° C. to -20° C. over three hours
  4. filtrationfiltered
  5. customto remove insoluble substances
  6. extractionThe obtained filtrate was extracted with ether
  7. extractionthe resultant extract
  8. washwas washed with water
  9. extractionThe resultant extract
  10. dry with materialwas then dried with anhydrous magnesium sulfate
  11. filtrationfiltered
  12. concentrationThe filtrate was then concentrated
  13. dissolutionThe obtained residue was dissolved in 20 ml of methanol
  14. addition20 ml of 10% sodium hydroxide were added
  15. stirringthe solution was stirred at room temperature for three hours
  16. distillationAfter that, the methanol in the solution was distilled off under reduced pressure
  17. extractionthe obtained residue was extracted twice with diethyl ether
  18. customthe organic layer was separated from the obtained
  19. extractionextract
  20. extractionextracted with diethyl ether five times
  21. extractionThe obtained extract
  22. customas obtained before
  23. dry with materialThe combined organic layer was dried with anhydrous magnesium sulfate
  24. concentrationconcentrated
  25. customto obtain the crude product
  26. customThis crude product was purified via silica gel column chromatogrpahy (n-hexane:ether=10:1 to 2.1)
  27. distillationdistilled under reduced pressure

Quellen und Nachweise

ORD-Eintrag
ord-f85710ffbc4f4729accdbff703b65ea5
Quelldatensatz
uspto-grants-1993_06
DOI
10.6084/m9.figshare.5104873.v1
Patentnummer
US05216177

Notizen zur Reaktion

Auf dieser SeiteKomponentenReaktionsbedingungenVersuchsvorschriftAufarbeitungQuellen und NachweiseNotizen zur Reaktion