StartseiteMCPWorkbenchSkills
StartseiteWorkbenchBenachrichtigungenMein Bereich
llms.txt · MCP-AnleitungDatenschutz · Nutzungsbedingungen · Supportv1.8.3
  1. Startseite
  2. /Reaktion

Acetic Acid → 8b,9a-Dihydropyreno(4,5-b)oxirene

HRID 2393878
Drucken

Reaktionsgleichung

Reaktionsgleichung von HRID 2393878
OO.[CH:3]1[C:16]2[CH:15]=[CH:14][C:13]3[C:8](=[CH:9][CH:10]=[CH:11][CH:12]=3)[C:7]=2[CH:6]=[CH:5][CH:4]=1.C1C2C3=C4C(=CC=2)C=CC=C4C=CC3=CC=1.C(N=C=NC(C)C)(C)C.[C:42]([OH:45])(=O)[CH3:43].C1C=C2C3OC3C3C(C2=CC=1)=CC=CC=3>C(OCC)(=O)C>[CH:4]1[CH:5]=[C:6]2[CH:42]3[O:45][CH:43]3[C:9]3[C:8]4[C:7]2=[C:16]([CH:15]=[CH:14][C:13]=4[CH:12]=[CH:11][CH:10]=3)[CH:3]=1
KomponentenVersuchsvorschriftQuellen und NachweiseNotizen zur Reaktion

Komponenten

8

Edukt 6

HCID 176Acetic AcidHCID 784Hydrogen Peroxide2×HCID 995Phenanthrene4×HCID 12734DiisopropylcarbodiimideHCID 31423Pyrene2×HCID 1049751a,9b-Dihydrophenanthro(9,10-b)oxirene

Produkt 1

HCID 108016
8b,9a-Dihydropyreno(4,5-b)oxirene
Ausbeute 27 %

Reagenzien, Katalysatoren, Lösungsmittel 1

HCID 8857Ethyl AcetateLösungsmittel2×

Versuchsvorschrift

Anhydrous hydrogen peroxide (98%) and carbodiimides were used in acidic ethyl acetate, an aprotic solvent, to epoxidize two arenes, phenanthrene and pyrene, but only in about 3% yield, based on the initial amount of the arene (Hamilton et al., Tet. Lett, 1977, 16, 1369). For example, phenanthrene (4 mmol), diisopropylcarbodiimide (8 mmol), 98% hydrogen peroxide (16 mmol), and acetic acid (8 mmol) were reacted in ethyl acetate. The yield of phenanthrene 9, 10-oxide was 28% based on the amount of reacted phenanthrene and 2.9% based on the amount of phenanthrene initially present. A reaction of pyrene under similar conditions yielded pyrene 4,5-oxide in 27% yield, based on the amount of reacted pyrene; the yield based on the amount of pyrene initially present was not stated. These researchers state that, "Control experiments indicate that all four components (arene, carbodiimide, H2O2, and acid) are required for the reaction." They also state that approximately the same yield of oxide is formed from these arenes when 30% hydrogen peroxide, and a four-fold increase in the carbodiimide concentration, are used instead of 98% hydrogen peroxide. The authors also speculate that, "In addition to its use in arene oxide synthesis, the carbodiimide-H2O2 system may be useful for simple alkene epoxidations under mild conditions," and make reference to three earlier articles. Two of the references cited by the authors, however, refer to systems using reagents other than carbodiimides to effect epoxidation of olefins. One reference cited (Rebek, J., Jr. et al., J. Chem. Soc. Chem. Commun., 1974, 711) reports that substituted peroxycarbamic acids, generated in situ from anhydrous hydrogen peroxide and carbonyldiimidazole, can be used to epoxidize olefins. A second reference cited (Matsumura et al. Tet. Lett. 1970, 2029.) reports that reaction of an isocyanate and hydrogen peroxide, in the presence of an olefin, leads to epoxidation of olefins.

Quellen und Nachweise

ORD-Eintrag
ord-7a23d3ee20434d76b46503cd78f85c90
Quelldatensatz
uspto-grants-1998_09
DOI
10.6084/m9.figshare.5104873.v1
Patentnummer
US05808115

Notizen zur Reaktion

Auf dieser SeiteKomponentenVersuchsvorschriftQuellen und NachweiseNotizen zur Reaktion