StartseiteMCPWorkbenchSkills
StartseiteWorkbenchBenachrichtigungenMein Bereich
llms.txt · MCP-AnleitungDatenschutz · Nutzungsbedingungen · Supportv1.8.3
  1. Startseite
  2. /Reaktion

Benzoyl chloride → 4-Methylbenzophenone

HRID 248783
Drucken

Reaktionsgleichung

Reaktionsgleichung von HRID 248783
Cl[C:2]1[CH:7]=[CH:6][C:5](C)=[CH:4][CH:3]=1.[Ca].[C:10]([Cu])#N.[Li+].[Br-].[C:15](Cl)(=[O:22])[C:16]1[CH:21]=[CH:20][CH:19]=[CH:18][CH:17]=1.[NH4+].[Cl-]>C1COCC1>[CH3:10][C:19]1[CH:20]=[CH:21][C:16]([C:15]([C:2]2[CH:7]=[CH:6][CH:5]=[CH:4][CH:3]=2)=[O:22])=[CH:17][CH:18]=1
KomponentenReaktionsbedingungenVersuchsvorschriftAufarbeitungQuellen und NachweiseNotizen zur Reaktion

Komponenten

8

Edukt 6

HCID 7412Benzoyl chlorideHCID 78104-ChlorotolueneHCID 25517Ammonium ChlorideHCID 82050Lithium BromideHCID 5460341CalciumHCID 178418546HCID 178418546, Verbindung3×

Produkt 1

HCID 8652
4-Methylbenzophenone
Ausbeute 86 %

Reagenzien, Katalysatoren, Lösungsmittel 1

HCID 8028TetrahydrofuranLösungsmittel2×

Reaktionsbedingungen

Temperatur
-35 °C

Versuchsvorschrift

The following experimental procedure is representative of the reactions set forth below in Table II. The organocalcium reagent (2.72 mmol) was prepared from p-chlorotoluene (344 mg, 2.72 mmol) and highly reactive calcium (3.15 mmol) as described above. CuCN.2LiBr in THF (10 mL) was added to the organocalcium reagent via a cannula at -35° C. The CuCN.2LiBr can be prepared from CuCN and approximately two equivalents of LiBr in THF, as outlined in P. Knochel et al., J. Org. Chem., 53, 2390 (1989), which is incorporated herein by reference. The reaction mixture was stirred at -35° C. for 30 minutes. Benzoyl chloride (950 mg, 6.76 mmol) was added to the mixture via a disposable syringe at -35° C. and the resulting mixture was gradually warmed to room temperature. Saturated aqueous NH4Cl solution (20 mL) was then added to the reaction mixture at room temperature for the purpose of neutralizing the reaction mixture. The reaction mixture was then filtered through a small pad of Celite™ filter agent and was washed with Et2O (50 mL). The aqueous layer was extracted with Et2O (2×30 mL). The combined organic phases were washed with H2O (3×15 mL) and dried over anhydrous MgSO4. Removal of solvent and flash-column chromatography on silica gel (100 g, 230-400 mesh, eluted sequentially with 20:1 hexanes/EtOAc, 15:1 hexanes/EtOAc, and 10:1 hexanes/EtOAc) yielded (4-methylphenyl)phenylmethanone (458 mg, 86% yield): IR (neat) 3058, 3027, 2921, 1658, 1606, 1446, 1317, 1278, 1178, 937, 924, 835, 787, 730, 700 cm-1 ; 1H NMR (200 MHz, CDCl3) δ 7.24-7.82 (m, 9 H), 2.43 (s, 3 H); 13C NMR (50 MHz, CDCl3) δ 196.4, 143.2, 137.9, 134.8, 132.1, 130.3, 129.9 128.9, 128.2, 21.6.

Aufarbeitung

  1. temperaturethe resulting mixture was gradually warmed to room temperature
  2. filtrationThe reaction mixture was then filtered through a small pad of Celite™
  3. filtrationfilter agent
  4. washwas washed with Et2O (50 mL)
  5. extractionThe aqueous layer was extracted with Et2O (2×30 mL)
  6. washThe combined organic phases were washed with H2O (3×15 mL)
  7. dry with materialdried over anhydrous MgSO4
  8. customRemoval of solvent and flash-column chromatography on silica gel (100 g, 230-400 mesh
  9. washeluted sequentially with 20:1 hexanes/EtOAc, 15:1 hexanes/EtOAc, and 10:1 hexanes/EtOAc)

Quellen und Nachweise

ORD-Eintrag
ord-ee4b17a80a984d2994c66b62489a76ed
Quelldatensatz
uspto-grants-1993_05
DOI
10.6084/m9.figshare.5104873.v1
Patentnummer
US05211889

Notizen zur Reaktion

Auf dieser SeiteKomponentenReaktionsbedingungenVersuchsvorschriftAufarbeitungQuellen und NachweiseNotizen zur Reaktion