[Cl-].[Al+3].[Cl-].[Cl-].ClC1C=CC=CC=1Cl.[F:13][C:14]1[CH:19]=[CH:18][CH:17]=[C:16]([CH3:20])[C:15]=1[CH3:21].FC1C=CC([CH:27]=[O:28])=C(C)C=1C>Cl>[F:13][C:14]1[C:15]([CH3:21])=[C:16]([CH3:20])[CH:17]=[CH:18][C:19]=1[CH:27]=[O:28]67.60 g of aluminum chloride (mol. Wt. 133.34; 507.0 mmol), 450.0 g of 1,2-dichlorobenzene (mol. Wt. 147.00; 3,061 mmol), and about 503.54 g of 3-fluoro-o-xylene (mol. Wt. 124.16; 789.3 mmol) were charged to a 2 liter Parry -brand 4522 stainless steel reaction vessel. To this mixture was added 5 drops of concentrated HCl. The vessel was sealed, heated to 50° C., and purged three times with carbon monoxide with the pressure of the vessel increased to 100 psi for each purging. After the third purge, the vessel was vented and a final introduction of CO was made at a pressure of about 200 psi, the pressure at which the reaction was maintained for the total reaction time of about 28 hours (the reaction temperature was maintained at 50° C. for the duration as well). Once the reaction was complete, the resultant mixture (exhibiting a dark orange color) was poured into about 500 mL of ice water (which turned the solution a yellow color), to which was added 500 mL of cyclohexane. The top, organic layer was removed and washed three times with water using a separatory funnel and dried over magnesium sulfate. The residual organic phase was then distilled under vacuum to remove excess cyclohexane, 3-fluoro-o-xylene, 1,2-dichlorobenzene, and left about 94.98 g of a benzaldehyde mixture consisting of 4-fluoro-2,3-dimethylbenzaldehyde (89.1 %) and 2-fluoro-3,4-dimethylbenzaldehyde (10.9%) (mol. Wt. 152.17; 624.2 mmol; yield of approximately 79.1%).