Acetone → disodium heptadecanoyl-L-aspartate

関与物質

反応条件

反応手順

In a one L three-necked flask were placed 16.0 g (0.12 mol) of L-aspartic acid and an aqueous solution of 9.6 g (0.24 mol) of sodium hydroxide in 150 mL of water under stirring. After the L-aspartic acid was dissolved, 120 mL of acetone was added to the mixture in the flask. Then, to the resultant reaction liquid which had been cooled to 0° C. were added dropwise over a period of 30 minutes, 29.0 g (0.1 mol) of heptadecanoyl chloride and an aqueous solution of 4 g sodium hydroxide in 30 mL of water, while maintaining the reaction temperature at 0 to 5° C. and pH at 11 to 12. Thereafter, by gradually raising the temperature of the reaction liquid to room temperature (25° C.) under stirring over a period of 2 hours, a solution of disodium heptadecanoyl-L-aspartate was obtained. To the resultant solution was added 65 mL of 5N hydrochloric acid to lower the pH of the solution to 1. The crystal thus precipitated was separated from the solution by means of vacuum filtration, washed with water and dried under reduced pressure. The resultant crystal was washed with 500 mL of hexane, dried and recrystallized from a mixed solvent of ethanol/water (8:1). As a result 21.0 g (0.054 mol) of N-heptadecanoyl-L-aspartic acid was obtained in a yield of 54.3% based on the fed heptadecanoyl chloride. The physical properties of the objective N-heptadecanoyl-L-aspartic acid were as follows.

情報源と証拠