홈MCP워크벤치Skills
홈워크벤치알림마이페이지
llms.txt · MCP 가이드개인정보처리방침 · 이용약관 · 지원v1.8.3
  1. 홈
  2. /반응

Hydrochloric Acid → 1-Azido-2-hydroxy-3-tosyloxypropane

HRID 1011458
인쇄

반응식

HRID 1011458 반응식
[N:1]([CH2:4][CH:5]1[CH2:9][O:8]C(C)(C)[O:6]1)=[N+:2]=[N-:3].Cl.[S:13](Cl)([C:16]1[CH:22]=[CH:21][C:19]([CH3:20])=[CH:18][CH:17]=1)(=[O:15])=[O:14].O>CO.C(OCC)C>[CH3:20][C:19]1[CH:21]=[CH:22][C:16]([S:13]([O:8][CH2:9][CH:5]([OH:6])[CH2:4][N:1]=[N+:2]=[N-:3])(=[O:15])=[O:14])=[CH:17][CH:18]=1
참가 물질실험 절차후처리출처 및 근거반응 노트

참가 물질

7

반응물 4

HCID 313Hydrochloric AcidHCID 962WaterHCID 73974-Toluenesulfonyl chlorideHCID 115356024-(Azidomethyl)-2,2-dimethyl-1,3-dioxolane

생성물 1

HCID 142837971-Azido-2-hydroxy-3-tosyloxypropane수율 49%

시약·촉매·용매 2

HCID 887Methanol
용매
HCID 3283Diethyl Ether용매

실험 절차

4-(Azidomethyl)-2,2-dimethyl-1,3-dioxolane 13 (2.2 g, 13.99 mmol) was dissolved in methanol (25 mL). To this solution was added a solution of HCl in diethyl ether (2M, 5 mL) at 0° C. The mixture was stirred at room temperature overnight, and then concentrated under reduced pressure to afford a yellow oil which was used for the next step without purification. After drying for 0.5 hr, the residue was dissolved in CH2Cl2 (30 mL) and was treated with Bu2SnO (0.071 mg, 0.3 mmol), followed by TsCl (2.86 g, 15.0 mmol) and TEA (2.2 mL, 16 mmol). After stirring for 3 hr at room temperature, water (30 mL) was added and the organic layer was separated. The aqueous layer was extracted with CH2Cl2 (2×50 mL) and the organic layer was consecutively washed with H2O (50 mL) and brine (50 mL) and dried over MgSO4. The solvent was removed under vacuum and the residue was purified on silica gel using 33% EtOAc/hexanes as the eluent to afford 1.86 g of 14 (48% yield) as a clear, colorless oil. 1H NMR (CDCl3, 400 MHz) δ: 7.77 (d, J=8.0 Hz, 2H), 7.34 (d, J=8.0 Hz, 2H), 3.96-4.09 (m, 3H), 3.31-3.40 (m, 2H), 2.43 (s, 3H). Mass Spec (lo-res): Calc'd for C10H13N3O4S: 271.06; found: 294.1 (M+Na+).

후처리

  1. concentrationconcentrated under reduced pressure
  2. customto afford a yellow oil which
  3. customwas used for the next step without purification
  4. customAfter drying for 0.5 hr
  5. dissolutionthe residue was dissolved in CH2Cl2 (30 mL)
  6. additionwas treated with Bu2SnO (0.071 mg, 0.3 mmol)
  7. stirringAfter stirring for 3 hr at room temperature
  8. customthe organic layer was separated
  9. extractionThe aqueous layer was extracted with CH2Cl2 (2×50 mL)
  10. washthe organic layer was consecutively washed with H2O (50 mL) and brine (50 mL)
  11. dry with materialdried over MgSO4
  12. customThe solvent was removed under vacuum
  13. customthe residue was purified on silica gel using 33% EtOAc/hexanes as the eluent

출처 및 근거

ORD 기록
ord-6efb7480e095427484b46922b5eaf57a
출처 데이터셋
uspto-grants-2011_07
DOI
10.6084/m9.figshare.5104873.v1
특허 번호
US07977361B2

반응 노트

이 페이지에서참가 물질실험 절차후처리출처 및 근거반응 노트