홈MCP워크벤치Skills
홈워크벤치알림마이페이지
llms.txt · MCP 가이드개인정보처리방침 · 이용약관 · 지원v1.8.3
  1. 홈
  2. /반응

1,2-Dimethoxyethane → 9-[4'-(benzoxazol-2-yl)biphenyl-4-yl]-9H-carbazole

HRID 1028868
인쇄

반응식

HRID 1028868 반응식
I[C:2]1[CH:7]=[CH:6][C:5]([C:8]2[O:9][C:10]3[CH:16]=[CH:15][CH:14]=[CH:13][C:11]=3[N:12]=2)=[CH:4][CH:3]=1.[CH:17]1[C:29]2[N:28]([C:30]3[CH:35]=[CH:34][C:33](B(O)O)=[CH:32][CH:31]=3)[C:27]3[C:22](=[CH:23][CH:24]=[CH:25][CH:26]=3)[C:21]=2[CH:20]=[CH:19][CH:18]=1.COCCOC.C(=O)([O-])[O-].[K+].[K+]>C([O-])(=O)C.[Pd+2].C([O-])(=O)C.C1(C)C=CC=CC=1P(C1C=CC=CC=1C)C1C=CC=CC=1C.C1(C)C=CC=CC=1>[O:9]1[C:10]2[CH:16]=[CH:15][CH:14]=[CH:13][C:11]=2[N:12]=[C:8]1[C:5]1[CH:6]=[CH:7][C:2]([C:33]2[CH:34]=[CH:35][C:30]([N:28]3[C:27]4[CH:26]=[CH:25][CH:24]=[CH:23][C:22]=4[C:21]4[C:29]3=[CH:17][CH:18]=[CH:19][CH:20]=4)=[CH:31][CH:32]=2)=[CH:3][CH:4]=1
참가 물질반응 조건실험 절차후처리출처 및 근거반응 노트

참가 물질

8

반응물 4

HCID 80711,2-DimethoxyethaneHCID 11430Potassium CarbonateHCID 28294142-(4-Iodophenyl)benzoxazoleHCID 231208274-(9H-Carbazol-9-yl)phenylboronic Acid

생성물 1

HCID 584351689-[4'-(benzoxazol-2-yl)biphenyl-4-yl]-9H-carbazole수율 88.7%

시약·촉매·용매 3

HCID 80271
Tri-o-tolylphosphine
촉매
HCID 167845palladium(II) acetate촉매
HCID 1140Toluene용매

반응 조건

온도
90 °C

실험 절차

In a 100 mL three-neck flask were put 1.0 g (3.1 mmol) of 2-(4-iodophenyl)benzoxazole, 0.90 g (3.1 mmol) of 4-(9H-carbazol-9-yl)phenylboronic acid, and 0.067 g (0.22 mmol) of tri(ortho-tolyl)phosphine. To this mixture were added 30 mL of 1,2-dimethoxyethane (abbreviation: DME) and 30 mL of a 2M potassium carbonate aqueous solution. This mixture was degassed under reduced pressure, and then the atmosphere in the flask was replaced with nitrogen. To this mixture was added 7.0 mg (0.031 mmol) of palladium(II)acetate, and the resulting mixture was stirred at 90° C. for 5 hours while being heated. After that, toluene was added to this mixture, and the organic layer was washed with a saturated aqueous sodium carbonate solution and saturated brine in that order. After that, magnesium sulfate was added to the organic layer to dry it. Next, this mixture was suction filtered. The resulting filtrate was suction filtered through Celite (produced by Wako Pure Chemical Industries, Ltd., Catalog No. 531-16855). The resulting filtrate was concentrated, followed by purification by silica gel column chromatography. As a developing solvent for the chromatography, toluene was used. The fraction obtained was concentrated to give a solid. This solid was recrystallized with a mixed solvent of chloroform and methanol to give 1.2 g of a white powdered solid in a yield of 88%.

후처리

  1. customIn a 100 mL three-neck flask were put
  2. customThis mixture was degassed under reduced pressure
  3. temperaturewhile being heated
  4. washthe organic layer was washed with a saturated aqueous sodium carbonate solution and saturated brine in that order
  5. additionAfter that, magnesium sulfate was added to the organic layer
  6. customto dry it
  7. filtrationfiltered
  8. filtrationfiltered through Celite (produced by Wako Pure Chemical Industries, Ltd., Catalog No. 531-16855)
  9. concentrationThe resulting filtrate was concentrated
  10. customfollowed by purification by silica gel column chromatography
  11. customThe fraction obtained
  12. concentrationwas concentrated
  13. customto give a solid
  14. customThis solid was recrystallized with a mixed solvent of chloroform and methanol

출처 및 근거

ORD 기록
ord-336d226137514062b98d9f4d8e322afd
출처 데이터셋
uspto-grants-2014_05
DOI
10.6084/m9.figshare.5104873.v1
특허 번호
US08735597B2

반응 노트

이 페이지에서참가 물질반응 조건실험 절차후처리출처 및 근거반응 노트