홈MCP워크벤치Skills
홈워크벤치알림마이페이지
llms.txt · MCP 가이드개인정보처리방침 · 이용약관 · 지원v1.8.3
  1. 홈
  2. /반응

Carbazole → 4,4'-Bis(9H-carbazol-9-yl)biphenyl

HRID 1037511
인쇄

반응식

HRID 1037511 반응식
I[C:2]1[CH:7]=[CH:6][C:5]([C:8]2[CH:13]=[CH:12][C:11](I)=[CH:10][CH:9]=2)=[CH:4][CH:3]=1.[CH:15]1[C:27]2[NH:26][C:25]3[C:20](=[CH:21][CH:22]=[CH:23][CH:24]=3)[C:19]=2[CH:18]=[CH:17][CH:16]=1.C([O-])([O-])=O.[K+].[K+].C1O[CH2:50][CH2:49]OCCOCCOCCOCCOC1>[Cu].C(Cl)Cl.ClC1C=CC=CC=1Cl>[CH:3]1[C:4]2[N:26]([C:25]3[CH:20]=[CH:21][C:22]([C:50]4[CH:49]=[CH:27][C:15]([N:26]5[C:25]6[CH:24]=[CH:23][CH:22]=[CH:21][C:20]=6[C:19]6[C:27]5=[CH:15][CH:16]=[CH:17][CH:18]=6)=[CH:16][CH:17]=4)=[CH:23][CH:24]=3)[C:13]3[C:8](=[CH:9][CH:10]=[CH:11][CH:12]=3)[C:5]=2[CH:6]=[CH:7][CH:2]=1
참가 물질반응 조건실험 절차후처리출처 및 근거반응 노트

참가 물질

8

반응물 4

HCID 6854CarbazoleHCID 11430Potassium Carbonate2회HCID 2855718-Crown-6HCID 763484,4'-Diiodo-1,1'-biphenyl

생성물 1

HCID 112487164,4'-Bis(9H-carbazol-9-yl)biphenyl

시약·촉매·용매 3

HCID 23978Copper촉매
HCID 6344
Dichloromethane
용매
HCID 72391,2-Dichlorobenzene용매

반응 조건

온도
180 °C

실험 절차

4,4′-Diiodobiphenyl (10.001 g, 24.63 mmol), carbazole (9.078 g, 54.29 mmol), K2CO3 (20.087 g, 145.34 mmol), 18-crown-6 (0.100 g, 0.34 mmol), and copper powder (10.051 g, 158.16 mmol) were combined in reaction flask. To the flask, o-dichlorobenzene (50 mL) was added. The reaction was heated under inert N2 atmosphere at 180° C. overnight. TLC showed evidence of limited di-substitution product which necessitated the addition of K2CO3 (4.994 g, 36.13 mmol) and Cu powder (5.223 g, 82.19 mmol) to the reaction flask to promote di-substitution. The reaction was allowed to proceed overnight. Additional reagents had no noticeable effect on the reaction so the reaction was stopped. Insoluble material was removed by vacuum filtration and washed with several portions of THF. On standing, a crystalline product crashed out of the filtrate. Further crystallization was promoted by the addition of a large amount of methanol. The precipitate was vacuum filtered to isolate. TLC (hexanes: DCM=8:2) confirmed precipitate was product with minor impurity. Purification was accomplished by dissolving the precipitate in hot boiling THF followed by filtration to obtain a green insoluble impurity. The product began to precipitate on standing and cooling. The filtrate/product mixture was dried under vacuum until the product started crashing out of solution and methanol was added to promote full precipitation. The product was isolated by vacuum filtration and air dried (24 hours). A cream colored flaky product was obtained (7.660 g, 64.2%).

후처리

  1. customon the reaction so the reaction
  2. customInsoluble material was removed by vacuum filtration
  3. washwashed with several portions of THF
  4. customFurther crystallization
  5. additionwas promoted by the addition of a large amount of methanol
  6. filtrationfiltered
  7. customto isolate
  8. customPurification
  9. dissolutionby dissolving the precipitate
  10. filtrationfollowed by filtration
  11. customto obtain a green insoluble impurity
  12. customto precipitate
  13. temperaturecooling
  14. customThe filtrate/product mixture was dried under vacuum until the product
  15. additionwas added
  16. customprecipitation
  17. customThe product was isolated by vacuum filtration and air
  18. customdried (24 hours)
  19. customwas obtained (7.660 g, 64.2%)

출처 및 근거

ORD 기록
ord-61f3dbe1a16245648fd443679caa1887
출처 데이터셋
uspto-grants-2013_10
DOI
10.6084/m9.figshare.5104873.v1
특허 번호
US08546505B2

반응 노트

이 페이지에서참가 물질반응 조건실험 절차후처리출처 및 근거반응 노트