홈MCP워크벤치Skills
홈워크벤치알림마이페이지
llms.txt · MCP 가이드개인정보처리방침 · 이용약관 · 지원v1.8.1
  1. 홈
  2. /반응

Carbon Tetrachloride → Neoheptanoyl chloride

HRID 1045269
인쇄

반응식

HRID 1045269 반응식
C1C=CC(P(C2C=CC=CC=2)C2C=CC=CC=2)=CC=1.[C:20]([OH:28])(=O)[CH2:21][CH2:22][C:23]([CH3:26])([CH3:25])[CH3:24].CC(C)(CCC)C(O)=O.C(C(C)(CC)C(O)=O)C.CC(C)(C(C)C)C(O)=O.P.C(Cl)(Cl)(Cl)[Cl:58]>O>[C:20]([Cl:58])(=[O:28])[CH2:21][CH2:22][C:23]([CH3:26])([CH3:25])[CH3:24]
참가 물질반응 조건실험 절차후처리출처 및 근거반응 노트

참가 물질

9

반응물 7

HCID 5943Carbon Tetrachloride2회HCID 11776TriphenylphosphineHCID 142374,4-Dimethylpentanoic acidHCID 144552,2-Dimethylpentanoic acidHCID 24404PhosphineHCID 298462-Ethyl-2-methylbutyric acidHCID 6397972,2,3-Trimethylbutyric acid

생성물

1
HCID 14921487Neoheptanoyl chloride

시약·촉매·용매 1

HCID 962Water용매

반응 조건

온도
80 °C

실험 절차

A 604.45 g (2.3 mol, 1 eq.) portion of PPh3 was dissolved in 724 mL CCl4 in a 2 L three-necked round-bottom flask under N2 to give a hazy solution. A stirbar was added and the flask was fitted with a water-cooled condenser topped with a N2 inlet/outlet, mechanical stirrer and shaft, and an addition funnel. The addition funnel was charged with a solution of ExxonMobil Neoheptanoic Acid Prime (300 g, 2.30 mol uncorrected for purity) in 300 mL CCl4. This material was 94.1% purity with an isomer balance of 43.0% 2,2-dimethylpentanoic acid (DMPA), 37.6% 2-ethyl-2-methylbutanoic acid (EMBA), and 13.5% 2,2,3-trimethylbutanoic acid (TMBA) by GC analysis (using FID detection; uncorrected for response factor). The acid solution was added dropwise at room temperature while stirring over a 1 hour period. No immediate reaction was observed other than a decrease in haziness to give a clear solution. After stirring under N2 for an additional hour at room temperature, the addition funnel was removed and the contents of the flask were heated at reflux (˜80° C.) for 3 h. The formation of a white precipitate was observed upon heating. Subsequently, the mixture was cooled to room temperature and filtered. Solvent was removed from the filtrate using a rotary evaporator. The residue was cooled in a refrigerator for 24 h and subsequently crushed with a spatula and extracted with 800 mL hexane for 2 hours. Solids were removed by filtration and the hexane filtrate depleted of volatiles using a rotary evaporator and high vacuum (at 50° C.) to give 200 g of a crude material containing product, phosphine-containing residues, unreacted acid, and other species (most likely neoheptanoic anhydrides). Fractional distillation of the crude material gave neoheptanoic acid chloride as the first boiling fraction (50° C./2.4×10−2 torr; 57.4 g, 17%); higher boiling fractions contained species assigned as neoheptanoic anhydrides (13C NMR C═O 173.1-173.0 ppm; IR υC═O 1808 and 1741 cm−1) and free acids. Elemental analysis calc. for C17H13ClO: C, 56.57; H, 8.82; Cl, 23.85; O, 10.76. Found: C, 56.64; H, 8.96; Cl, 23.60. 1H NMR (CDCl3, 400 MHz): δ 2.17 (septet, J=6.9 Hz, CHMe2 of TMBA), 1.81 (app. sextet, J=7.3 Hz), 1.64-1.53 (m), and 1.35-1.29 (m) (probably CH2 groups of EMBA and DMPA), 1.28 (s, probably CMe2 of DMPA), 1.21 and 1.20 (2 singlets, probably CMeEt of EMBA and CMe2 of TMBA), 0.94-0.88 (m, CHMe2 of TMBA, CH2Me of EMBA, and CH2Me of DMPA). 13C NMR (CDCl3, 125 MHz): δ 180.53 (C═O of TMBA), 180.11 (C═O of DMPA), 179.75 (C═O of EMBA), 57.23 (CMeEt of EMBA), 56.17 (CMe2 of TMBA), 52.84 (CMe2 of DMPA), 42.55 (CH2 of DMPA), 34.34 (CHMe2 of TMBA), 31.41 (CH2 of EMBA), 25.11 (CMe2 of DMPA), 21.46 (CMe2 of TMBA), 20.38 (CMeEt of EMBA), 17.93 (CH2Me of DMPA), 17.22 (CHMe2 of TMBA), 14.32 (CH2Me of DMPA), 8.58 (CH2Me of EMBA). Isomer ratio (average of C═O and CR2 resonances): 12.6% TMBA, 42.1% EMBA, 45.4% DMPA. IR (NaCl disk): 2970 (s), 2940 (sh), 2877 (sh), 1789 (vs, υC═O), 1698 (m, may be acid υC═O from incidental hydrolysis), 1460 (m), 1387 (w), 1369 (sh), 1194 (w), 1066 (w), 1009 (w), 975 (w), 961 (w), 916 (vs), 888 (m), 864 (m), 804 (vs), 756 (w), 743 (w) cm1.

후처리

  1. customto give a hazy solution
  2. additionA stirbar was added
  3. temperaturecooled condenser
  4. customtopped with a N2 inlet/outlet, mechanical stirrer
  5. additionThe acid solution was added dropwise at room temperature
  6. customNo immediate reaction
  7. customto give a clear solution
  8. stirringAfter stirring under N2 for an additional hour at room temperature
  9. customthe addition funnel was removed
  10. temperaturethe contents of the flask were heated
  11. temperatureupon heating
  12. temperatureSubsequently, the mixture was cooled to room temperature
  13. filtrationfiltered
  14. customSolvent was removed from the filtrate
  15. customa rotary evaporator
  16. temperatureThe residue was cooled in a refrigerator for 24 h
  17. customsubsequently crushed with a spatula
  18. extractionextracted with 800 mL hexane for 2 hours
  19. customSolids were removed by filtration
  20. customa rotary evaporator and high vacuum (at 50° C.)
  21. customto give 200 g of a crude material
  22. distillationFractional distillation of the crude material

출처 및 근거

ORD 기록
ord-0ff1cd88f9744dd69972581a62d97458
출처 데이터셋
uspto-grants-2013_10
DOI
10.6084/m9.figshare.5104873.v1
특허 번호
US08568846B2

반응 노트

이 페이지에서참가 물질반응 조건실험 절차후처리출처 및 근거반응 노트