홈MCP워크벤치Skills
홈워크벤치알림마이페이지
llms.txt · MCP 가이드개인정보처리방침 · 이용약관 · 지원v1.8.3
  1. 홈
  2. /반응

1-Bromo-2,3-difluorobenzene → (6S,9R)-6-(2,3-Difluorophenyl)-6,7,8,9-tetrahydro-9-[[tris(1-methylethyl)silyl]oxy]-5H-cyclohepta[b]pyridin-5-one

HRID 1099171
인쇄

반응식

HRID 1099171 반응식
CC(C)([O-])C.[Na+].C1(P(C2CCCCC2)C2C=CC=CC=2C2C=CC=CC=2C)CCCCC1.[CH:33]([Si:36]([CH:53]([CH3:55])[CH3:54])([CH:50]([CH3:52])[CH3:51])[O:37][C@H:38]1[C:44]2=[N:45][CH:46]=[CH:47][CH:48]=[C:43]2[C:42](=[O:49])[CH2:41][CH2:40][CH2:39]1)([CH3:35])[CH3:34].Br[C:57]1[CH:62]=[CH:61][CH:60]=[C:59]([F:63])[C:58]=1[F:64]>C([O-])(=O)C.[Pd+2].C([O-])(=O)C.C1(C)C=CC=CC=1>[F:63][C:59]1[C:58]([F:64])=[CH:57][CH:62]=[CH:61][C:60]=1[C@@H:41]1[CH2:40][CH2:39][C@@H:38]([O:37][Si:36]([CH:33]([CH3:35])[CH3:34])([CH:50]([CH3:52])[CH3:51])[CH:53]([CH3:55])[CH3:54])[C:44]2=[N:45][CH:46]=[CH:47][CH:48]=[C:43]2[C:42]1=[O:49]
참가 물질반응 조건실험 절차후처리출처 및 근거반응 노트

참가 물질

7

반응물 4

HCID 27332601-Bromo-2,3-difluorobenzeneHCID 27349382-(Dicyclohexylphosphino)-2'-methylbiphenylHCID 23676156Sodium t-butoxideHCID 57911448(R)-9-(triisopropylsilyloxy)-6,7,8,9-tetrahydro-5H-cyclohepta[b]pyridin-5-one

생성물 1

HCID 57911475(6S,9R)-6-(2,3-Difluorophenyl)-6,7,8,9-tetrahydro-9-[[tris(1-methylethyl)silyl]oxy]-5H-cyclohepta[b]pyridin-5-one

시약·촉매·용매 2

HCID 167845palladium(II) acetate촉매HCID 1140Toluene용매

반응 조건

온도
80 °C

실험 절차

See Fox, J. M.; Huang, X.; Chieffi, A.; Buchwald, S. L. J. Am. Chem. Soc. 2000, 122, 1360-1370. In an oven-dried 1 L flask was Sodium tert-butoxide (13.19 g, 137 mmol), PALLADIUM(II) ACETATE (0.948 g, 4.22 mmol), and 2-(Dicyclohexylphosphino)-2′-methylbiphenyl (1.539 g, 4.22 mmol) weighed in a nitrogen bag. (R)-9-(triisopropylsilyloxy)-6,7,8,9-tetrahydro-5H-cyclohepta[b]pyridin-5-one (35.21 g, 106 mmol), Toluene (106 mL) (degassed in the original bottle by nitrogen gas), and 1-bromo-2,3-difluorobenzene (14.18 mL, 127 mmol) were added under nitrogen. The flask stirred at 80° C. in a pre-heated oil bath for 20 h. Volatiles were stripped off and the residue was partitioned between EtOAc (400 ml) and water (400 ml). The layers were separated. The aqueous layer was extracted with EtOAc (50 ml). The combined organic layer was washed with brine, dried and concentrated to a dark oil. It was passed through a plug of silica gel (loaded with CH2Cl2 and eluted with EtOAc/hexane up to 30% EtOAc). The crude product was obtained as a dark red oil (86% mass recovery). 1H NMR showed approximately 6/1 ratio of the desired trans isomer to the cis isomer. MS (ESI)[M+H+]=446.21.

후처리

  1. customIn an oven-dried 1 L flask was
  2. additionwere added under nitrogen
  3. customthe residue was partitioned between EtOAc (400 ml) and water (400 ml)
  4. customThe layers were separated
  5. extractionThe aqueous layer was extracted with EtOAc (50 ml)
  6. washThe combined organic layer was washed with brine
  7. customdried
  8. concentrationconcentrated to a dark oil
  9. washeluted with EtOAc/hexane up to 30% EtOAc)

출처 및 근거

ORD 기록
ord-d8a008a97cc64ff095fe1741b284eac9
출처 데이터셋
uspto-grants-2012_03
DOI
10.6084/m9.figshare.5104873.v1
특허 번호
US08143403B2

반응 노트

이 페이지에서참가 물질반응 조건실험 절차후처리출처 및 근거반응 노트