홈MCP워크벤치Skills
홈워크벤치알림마이페이지
llms.txt · MCP 가이드개인정보처리방침 · 이용약관 · 지원v1.8.0
  1. 홈
  2. /반응

Sulfuric Acid → Ethyl 4-(3,4-dimethoxybenzoyl)-1H-1,2,3-triazole-5-carboxylate

HRID 1293119
노트
인쇄 미리보기

반응식

HRID 1293119 반응식
[N-:1]=[N+:2]=[N-:3].[Na+].Cl([O-])(=O)=O.[Na+].[CH3:10][O:11][C:12]1[CH:13]=[C:14]([C:20](=[O:28])[CH:21]=[CH:22][C:23]([O:25][CH2:26][CH3:27])=[O:24])[CH:15]=[CH:16][C:17]=1[O:18][CH3:19].N([O-])=O.[Na+].S(=O)(=O)(O)O>O.C(OCC)(=O)C.C(#N)C.CN(C)C=O>[CH3:10][O:11][C:12]1[CH:13]=[C:14]([CH:15]=[CH:16][C:17]=1[O:18][CH3:19])[C:20]([C:21]1[NH:3][N:2]=[N:1][C:22]=1[C:23]([O:25][CH2:26][CH3:27])=[O:24])=[O:28]
참가 물질반응 조건실험 절차후처리출처 및 근거반응 노트

참가 물질

10

반응물 5

HCID 1118Sulfuric AcidHCID 33557Sodium AzideHCID 516902Sodium ChlorateHCID 23668193Sodium NitriteHCID 53400457Ethyl 4-(3,4-dimethoxyphenyl)-4-oxo-2-butenoate

생성물 1

HCID 178470512Ethyl 4-(3,4-dimethoxybenzoyl)-1H-1,2,3-triazole-5-carboxylate수율 82.6%

시약·촉매·용매 4

HCID 962Water용매HCID 6228Dimethylformamide용매2회HCID 6342Acetonitrile용매HCID 8857Ethyl Acetate용매

반응 조건

온도
40 °C

실험 절차

Sodium azide (4.87 g, 75 mmol), sodium chlorate (2.90 g, 27 mmol), and a 37% aqueous ferric chloride solution (1.49 g, 3 mmol) were added to N,N-dimethylformamide (36 mL), the mixed solution was heated to 40° C., and a mixed solution previously prepared by adding ethyl 4-(3,4-dimethoxyphenyl)-4-oxo-2-butenoate (18 g, 68 mmol) to N,N-dimethylformamide (36 mL) and then dissolving them each other at 50° C. was added dropwise thereto. After the completion of the dropwise addition, a reaction was allowed to proceed at 40° C. for one hr, and a reaction was further allowed to proceed at 65° C. for one hr. After the completion of the reaction, the reaction solution was cooled to 5° C., and acetonitrile (7 mL) and an aqueous solution of sodium nitrite (1.18 g, 17 mmol) in water (25 mL) were successively added dropwise thereto. The mixture was adjusted to pH 1.5 by the addition of a 3 M aqueous sulfuric acid solution. The mixture was stirred at 5° C. for one hr, and ethyl acetate (198 ml) was then added thereto, followed by separation. The organic layer was washed three times with 5% brine, was dried over anhydrous magnesium sulfate, and was filtered. The filtrate was concentrated under the reduced pressure to precipitate crystals. Toluene (90 mL) was added to the residue of the concentration, and the crystals were aged at 5° C. for 12 hr. The crystals were collected by filtration, were then washed with toluene, and were dried under the reduced pressure to give 17.15 g of a light yellow powder (yield 82.5%).

후처리

  1. customa mixed solution previously prepared
  2. dissolutiondissolving them each other at 50° C.
  3. additionwas added dropwise
  4. additionAfter the completion of the dropwise addition
  5. waitto proceed at 65° C. for one hr
  6. customAfter the completion of the reaction
  7. temperaturethe reaction solution was cooled to 5° C.
  8. customfollowed by separation
  9. washThe organic layer was washed three times with 5% brine
  10. dry with materialwas dried over anhydrous magnesium sulfate
  11. filtrationwas filtered
  12. concentrationThe filtrate was concentrated under the reduced pressure
  13. customto precipitate crystals
  14. additionToluene (90 mL) was added to the residue of the concentration
  15. waitthe crystals were aged at 5° C. for 12 hr
  16. filtrationThe crystals were collected by filtration
  17. washwere then washed with toluene
  18. customwere dried under the reduced pressure

출처 및 근거

ORD 기록
ord-bd59fe30549d47df9d440051edfc3840
출처 데이터셋
uspto-grants-2007_07
DOI
10.6084/m9.figshare.5104873.v1
특허 번호
US07238719B2

반응 노트

불러오는 중…

이 페이지에서참가 물질반응 조건실험 절차후처리출처 및 근거반응 노트