홈MCP워크벤치Skills
홈워크벤치알림마이페이지
llms.txt · MCP 가이드개인정보처리방침 · 이용약관 · 지원v1.8.1
  1. 홈
  2. /반응

Oxygen → Qing Hau Sau

HRID 1479330
인쇄

반응식

HRID 1479330 반응식
[CH3:1][C@H:2]1[C@@H:7]2[CH2:8][CH2:9][C:10]([CH3:12])=[CH:11][C@@H:6]2[C@H:5]([C@H:13]([C:15]([OH:17])=[O:16])[CH3:14])[CH2:4][CH2:3]1.C(O)(C(F)(F)F)=[O:19].[O:25]=[O:26]>ClCCl.C1C=CC(C2C3NC(C(C4C=CC=CC=4)=C4C=CC(=C(C5C=CC=CC=5)C5C=CC(=C(C6C=CC=CC=6)C6C=CC=2N=6)N=5)N4)=CC=3)=CC=1>[CH3:1][C@H:2]1[C@@H:7]2[CH2:8][CH2:9][C@:10]3([CH3:12])[O:25][O:26][C@:6]42[C@H:5]([C@@H:13]([CH3:14])[C:15]([O:17][C@@H:11]4[O:19]3)=[O:16])[CH2:4][CH2:3]1
참가 물질반응 조건실험 절차후처리출처 및 근거반응 노트

참가 물질

6

반응물 3

HCID 977OxygenHCID 6422Trifluoroacetic acidHCID 11020893Dihydroartemisinic acid

생성물 1

HCID 9838675Qing Hau Sau수율 50%

시약·촉매·용매 2

HCID 701865,10,15,20-Tetraphenyl-21,22-dihydroporphyrin촉매HCID 6344
Dichloromethane
용매

반응 조건

온도
0 °C

실험 절차

A solution of dihydroartemisinic acid (4) (1.18 g, 5.0 mmol) and tetraphenylporphyrin (12 mg, 20 μmol) in dichloromethane (total volume of the solution: 10.0 mL, volumetric flask) was prepared. The lamp was turned on 30 min prior to the beginning of the experiment. The reactor was flushed with pure dichloromethane (2.5 mL/min) and oxygen (5 mL/min, 11.5 bar) for 5 min. The reagents were then injected at a flow rate of 2.5 mL/min and the flow of oxygen was readjusted to 5 mL/min (11.5 bar). After the injection of the entire solution of (4), the reactor was flushed with pure dichloromethane (2.5 mL/min) to recover all material. The reaction mixture was collected in a round bottom flask and was cooled down to 0° C. Oxygen was bubbled into the reaction mixture at atmospheric pressure. After 2 min of bubbling, TFA (0.19 mL, 2.5 mmol, 0.5 eq.) was added drop wise. The resulting mixture was stirred at 0° C. for 2 h, while maintaining the oxygen bubbling. Then, the reaction was quenched with a saturated aqueous solution of NaHCO3. The resulting biphasic mixture was stirred at room temperature until disappearance of the green colour. The phases were separated and the aqueous phase was extracted with dichloromethane (3 times). The combined organic layers were dried over anhydrous Na2SO4, filtered and concentrated under reduced pressure. Purification over silica gel (5%-20% EtOAc in cyclohexane) afforded artemisinin (0.707 g, 50%) as a yellow solid.

후처리

  1. customThe reactor was flushed with pure dichloromethane (2.5 mL/min) and oxygen (5 mL/min, 11.5 bar) for 5 min
  2. customAfter the injection of the entire solution of (4), the reactor was flushed with pure dichloromethane (2.5 mL/min)
  3. customto recover all material
  4. customThe reaction mixture was collected in a round bottom flask
  5. customOxygen was bubbled into the reaction mixture at atmospheric pressure
  6. customAfter 2 min of bubbling
  7. customThen, the reaction was quenched with a saturated aqueous solution of NaHCO3
  8. stirringThe resulting biphasic mixture was stirred at room temperature until disappearance of the green colour
  9. customThe phases were separated
  10. extractionthe aqueous phase was extracted with dichloromethane (3 times)
  11. dry with materialThe combined organic layers were dried over anhydrous Na2SO4
  12. filtrationfiltered
  13. concentrationconcentrated under reduced pressure
  14. customPurification over silica gel (5%-20% EtOAc in cyclohexane)

출처 및 근거

ORD 기록
ord-7e3bf4eea018495da19d88ff59ab03af
출처 데이터셋
uspto-grants-2016_08
DOI
10.6084/m9.figshare.5104873.v1
특허 번호
US09409142B2

반응 노트

이 페이지에서참가 물질반응 조건실험 절차후처리출처 및 근거반응 노트