홈MCP워크벤치Skills
홈워크벤치알림마이페이지
llms.txt · MCP 가이드개인정보처리방침 · 이용약관 · 지원v1.8.3
  1. 홈
  2. /반응

Dichloromethane → Isobutyl chloroformate

HRID 1597762
인쇄

반응식

HRID 1597762 반응식
[CH2:1]([O:8][C:9]([N:11]1[CH2:14][CH2:13][C@H:12]1[C:15](O)=O)=[O:10])[C:2]1[CH:7]=CC=C[CH:3]=1.N1CC[C@H:19]1C(O)=O.C(Cl)[Cl:26]>>[CH2:1]([O:8][C:9]([Cl:26])=[O:10])[CH:2]([CH3:7])[CH3:3].[CH3:19][CH:12]1[CH2:15][CH2:9][NH:11][CH2:14][CH2:13]1
참가 물질실험 절차후처리출처 및 근거반응 노트

참가 물질

5

반응물 3

HCID 6344DichloromethaneHCID 164862-Azetidinecarboxylic acid, (S)-HCID 12088656(2S)-1-(Benzyloxycarbonyl)azetidine-2-carboxylic acid

생성물 2

HCID 62365Isobutyl chloroformateHCID 693814-Methylpiperidine

실험 절차

A suspension of 1.200 g (5.10 mmoles) of N-benzyloxycarbonyl-(S)-(-)-2-azetidine-carboxylic acid (abbreviation Z-(S)-AzeOH, prepared from (S)-(-)-2-azetidinecarboxylic acid (Aldrich) according to the method of Wunsch) in 60 ml of dry methylene chloride (CH2Cl2) was brought in an argon atmosphere to a temperature of approximately -20° C. On stabilization of the temperature, the following were added in quick succession: 0.690 ml (5.27 mmoles) of isobutylchloroformate (IBCF) and 0.650 ml (5.34 mmoles) of 4-methylpiperidine (NMP), leaving the system under stirring for approximately 2 minutes. A solution, pre-cooled to approximately -15° C. for 30 minutes, of 1.850 g (5.03 mmoles) of (L)-Leu-(L)-TrpOMe.HCl (Novabiochem) and 0.620 ml (5.10 mmoles) of NMP in 25 ml of anhydrous N,N-dimethylformamide (DMF) was then added, leaving, under stirring and static argon, the temperature free to rise to room temperature. After approximately 3.5 hours of reaction, the white precipitate was filtered away and washed with a little CH2Cl2. The latter was put back into the pale yellow coloured organic solution, which was extracted in succession using 5% NaHCO3 (3×30 ml); saturated aqueous NaCl (2×30 ml); 4% KHSO4 (3×30 ml) and finally saturated aqueous NaCl (3×30 ml), discarding the aqueous phases. The organic phase extracted, of a pale yellow colour, was left in a cold chamber under argon and on anhydrous Na2SO4 for 12 hours. The desiccant was then filtered away and the organic solution, concentrated to a small volume, leaves a dense residual oil which, when taken up with a minimum amount of CH2Cl2, was purified using flash-chromatography in a normal phase (SiO2, eluant CH2 Cl2 /n-hexane: 2/1). The chromatographic fractions of interest were concentrated to a small volume and ground with anhydrous ethyl ether. The whiteish solid thus obtained was filteres and left for 24 hours under vacuum on P2O5. 2.040 g (75.0%) of an analytically pure rubbery white solid were recovered.

후처리

  1. customwas brought in an argon atmosphere to a temperature of approximately -20° C
  2. additionOn stabilization of the temperature, the following were added in quick succession

출처 및 근거

ORD 기록
ord-9a0cd2e7916a47ea9cfa5ea7d86ab62e
출처 데이터셋
uspto-grants-1998_04
DOI
10.6084/m9.figshare.5104873.v1
특허 번호
US05736518

반응 노트

이 페이지에서참가 물질실험 절차후처리출처 및 근거반응 노트