홈MCP워크벤치Skills
홈워크벤치알림마이페이지
llms.txt · MCP 가이드개인정보처리방침 · 이용약관 · 지원v1.8.3
  1. 홈
  2. /반응

Hydrochloric Acid → Chloromethoxy-cyclododecane

HRID 1730710
인쇄

반응식

HRID 1730710 반응식
[CH:1]1(O)[CH2:12][CH2:11][CH2:10][CH2:9][CH2:8][CH2:7][CH2:6][CH2:5][CH2:4][CH2:3][CH2:2]1.S([O-])([O-])(=O)=O.[Na+].[Na+].[CH2:21]=[O:22].[H][H].ClCl.[ClH:27]>C1(C)C(C)=CC=CC=1>[Cl:27][CH2:21][O:22][CH:1]1[CH2:12][CH2:11][CH2:10][CH2:9][CH2:8][CH2:7][CH2:6][CH2:5][CH2:4][CH2:3][CH2:2]1
참가 물질반응 조건실험 절차후처리출처 및 근거반응 노트

참가 물질

7

반응물 5

HCID 313Hydrochloric AcidHCID 712FormaldehydeHCID 15595CyclododecanolHCID 24436Sodium SulfateHCID 178478648HCID 178478648, 화합물

생성물 1

HCID 14640421Chloromethoxy-cyclododecane

시약·촉매·용매 1

HCID 7237
O-Xylene
용매

반응 조건

온도
-20 °C

실험 절차

368 gm of cyclododecanol (2.0 mols), 250 gm of anhydrous sodium sulfate and 66,0 gm of paraformaldehyde were dispersed in 600 ml of xylene and the mixture was cooled to a temperature of -20° C. While the mixture was stirred energetically, as strong a flow as possible of hydrogen chlorine was introduced, the speed at which it was introduced being controlled such that the reaction temperature did not exceed +5° C. After approximately one hour the speed of introduction was decreased and subsequent reaction was effected while hydrogen chloride was bubbled through gently. Water-jet vacuum was then applied gradually during energetic stirring in order to remove surplus hydrogen chloride. When the highest water-jet vacuum had been achieved, the mixture was heated to 30° C over a period of one hour, and subsequent stirring was effected at this temperature for a further hour. The sodium sulfate was then drawn off by vacuum filtration and the solution of the chloromethoxy-cyclododecane thus obtained could be used for the next reaction without special processing.

후처리

  1. additionthe speed at which it was introduced
  2. customdid not exceed +5° C
  3. customsubsequent reaction
  4. customwas bubbled through gently
  5. stirringduring energetic stirring in order
  6. customto remove surplus hydrogen chloride
  7. temperaturethe mixture was heated to 30° C over a period of one hour
  8. stirringsubsequent stirring
  9. waitwas effected at this temperature for a further hour
  10. filtrationThe sodium sulfate was then drawn off by vacuum filtration

출처 및 근거

ORD 기록
ord-b460c61173d345a9bd8ec29ce0f5c579
출처 데이터셋
uspto-grants-1976_11
DOI
10.6084/m9.figshare.5104873.v1
특허 번호
US03993697

반응 노트

이 페이지에서참가 물질반응 조건실험 절차후처리출처 및 근거반응 노트