홈MCP워크벤치Skills
홈워크벤치알림마이페이지
llms.txt · MCP 가이드개인정보처리방침 · 이용약관 · 지원v1.8.3
  1. 홈
  2. /반응

Bromide ion → 1,1-Diphenyl-hex-5-en-2-ol

HRID 1897877
인쇄

반응식

HRID 1897877 반응식
II.[Br-].[C:4]1([CH:10]([C:13]2[CH:18]=[CH:17][CH:16]=[CH:15][CH:14]=2)[CH:11]=[O:12])[CH:9]=[CH:8][CH:7]=[CH:6][CH:5]=1.C([O-])(O)=O.[Na+]>C(OCC)C.BrCCC=C>[C:13]1([CH:10]([C:4]2[CH:5]=[CH:6][CH:7]=[CH:8][CH:9]=2)[CH:11]([OH:12])[CH2:6][CH2:5][CH:4]=[CH2:9])[CH:14]=[CH:15][CH:16]=[CH:17][CH:18]=1
참가 물질실험 절차후처리출처 및 근거반응 노트

참가 물질

7

반응물 4

HCID 259Bromide ionHCID 807Iodine2회HCID 13696DiphenylacetaldehydeHCID 516892Sodium Bicarbonate

생성물 1

HCID 643145171,1-Diphenyl-hex-5-en-2-ol수율 165.3%

시약·촉매·용매 2

HCID 21241Homoallyl bromide촉매
HCID 3283
Diethyl Ether
용매
3회

실험 절차

A dry three-neck, round-bottom flask fitted with a reflux condensor, air-balance drop funnel and nitrogen inlet was charged with Mg (0.11 g, 4.44 mmol) and a crystal of I2. The flask was warmed (heat gun) to volatilize the I2 under vacuum, and then was allowed to cool. Dry ethyl ether (10 ml) was added next followed by introduction of catalytic neat 4-bromo-1-butene (0.02 g). The reaction was initiated by brief warming and then the rest of total amount of bromide (0.4 g, 2.96 mmol) in dry ethyl ether (5 ml) was added dropwise over 5 minutes. The mixture was refluxed for 30 minutes and then was allowed to reach 0° C. Into the stirred Grignard reagent solution was added dropwise a solution of diphenylacetaldehyde 1 (0.64 g, 3.26 mmol) in dry ethyl ether (5 ml), and the reaction mixture was stirred for an additional 3.5 hr at room temperature. Saturated aqueous NaHCO3 was added to the reaction mixture at 0° C., the organic phase was separated and the aqueous phase was extracted with ethyl ether (3×20 ml). The combined organic phases were washed with brine and water, then dried over anhydrous Na2SO4. The solvent was removed under reduced pressure, and flash chromatography of the crude residue (SiO2, hexane/Ethyl Acetate 9:1) gave 1,1-diphenyl-hex-5-en-2-ol 8 (0.68 g, 91%) as a liquid.

후처리

  1. customA dry three-neck, round-bottom flask fitted with a reflux condensor, air-balance drop funnel and nitrogen inlet
  2. temperatureThe flask was warmed
  3. temperature(heat gun)
  4. temperatureto cool
  5. temperatureby brief warming
  6. temperatureThe mixture was refluxed for 30 minutes
  7. customto reach 0° C
  8. customthe organic phase was separated
  9. extractionthe aqueous phase was extracted with ethyl ether (3×20 ml)
  10. washThe combined organic phases were washed with brine and water
  11. dry with materialdried over anhydrous Na2SO4
  12. customThe solvent was removed under reduced pressure, and flash chromatography of the crude residue (SiO2, hexane/Ethyl Acetate 9:1)

출처 및 근거

ORD 기록
ord-15fda95981944c0e9ac3885b10fdb89c
출처 데이터셋
uspto-grants-2013_08
DOI
10.6084/m9.figshare.5104873.v1
특허 번호
US08519159B2

반응 노트

이 페이지에서참가 물질실험 절차후처리출처 및 근거반응 노트