홈MCP워크벤치Skills
홈워크벤치알림마이페이지
llms.txt · MCP 가이드개인정보처리방침 · 이용약관 · 지원v1.8.3
  1. 홈
  2. /반응

4-Nitrophenethyl alcohol → 2-(4-Nitrophenyl)ethyl3-[(tert-butyl)oxycarbonyl]pyrrolo[4,5-e]indoline-7-carboxylate

HRID 2087108
인쇄

반응식

HRID 2087108 반응식
[C:1]([O:5][C:6]([N:8]1[C:19]2[C:11](=[C:12]3[C:16](=[CH:17][CH:18]=2)[NH:15][CH:14]([C:20]([OH:22])=[O:21])[CH2:13]3)[CH:10]=[CH:9]1)=[O:7])([CH3:4])([CH3:3])[CH3:2].N(C(OCC)=O)=NC(OCC)=O.C1(P(C2C=CC=CC=2)C2C=CC=CC=2)C=CC=CC=1.[N+:54]([C:57]1[CH:62]=[CH:61][C:60]([CH2:63][CH2:64]O)=[CH:59][CH:58]=1)([O-:56])=[O:55]>C(OCC)C.C1COCC1>[C:1]([O:5][C:6]([N:8]1[C:19]2[C:11](=[C:12]3[C:16](=[CH:17][CH:18]=2)[NH:15][CH:14]([C:20]([O:22][CH2:64][CH2:63][C:60]2[CH:59]=[CH:58][C:57]([N+:54]([O-:56])=[O:55])=[CH:62][CH:61]=2)=[O:21])[CH2:13]3)[CH:10]=[CH:9]1)=[O:7])([CH3:4])([CH3:2])[CH3:3]
참가 물질반응 조건실험 절차후처리출처 및 근거반응 노트

참가 물질

7

반응물 4

HCID 74944-Nitrophenethyl alcoholHCID 11776TriphenylphosphineHCID 220568ethyl N-ethoxycarbonyliminocarbamateHCID 667170523-(tert-Butyloxycarbonyl)pyrrolo[3,2-e]indoline-7-carboxylic acid

생성물 1

HCID 667170292-(4-Nitrophenyl)ethyl3-[(tert-butyl)oxycarbonyl]pyrrolo[4,5-e]indoline-7-carboxylate수율 85%

시약·촉매·용매

2
HCID 3283Diethyl Ether용매HCID 8028Tetrahydrofuran용매

반응 조건

온도
4 °C

실험 절차

Ten grams (33.1 mmol) of 3-[(tert-butyl)oxycarbonyl]pyrrolo[3,2-e]indoline-7-carboxylic acid (Boger, D. L., Coleman, R. S., Invergo, B. J. (1987) J. Org. Chem. 52, 1521.), well dried, are placed into an argon filled flask, and 84 mL of THF and 10.4 mL (66.2 mmol) of diethyl azodicarboxylate (DEAD) are added. Then a dropping funnel is placed atop the flask (flushed with argon) and a water bath (to cool the flask) is placed under it. A solution of 17.3 g (66 mmol) of triphenylphosphine and 6.64 g (39.7 mmol) of 2-(p-nitrophenyl) ethanol in 160 mL of ethyl ether is made. This solution is added to the dropping funnel, and then to the reaction flask, dropwise, with stirring. The reaction is allowed to proceed for an hour, at which time, a TLC analysis is done (2:1 hexanes/ethyl acetate) examined by UV (254 nm) to determine whether the reaction is complete. If it is complete, then the baseline spot (bluish) will disappear and the product, with an Rf of 0.55, will appear as a dark spot. Often, especially if the reactants are not entirely dry, another portion of triphenylphosphine and DEAD are required. If so, a tenth of the original amounts is usually sufficient, i.e., 1.73 g of triphenylphosphine and 1.04 mL of DEAD. These can be added neat to the stirred solution. Allow to react another hour, after which another TLC analysis usually reveals complete reaction. The product usually precipitates out in part; this is collected bt filtration and washed with methanol, then recrystallized by dissolving in a minimum amount (typically, 80-100 ml) of warm acetone and adding four times that volume of warm methanol. Cool to 4° C. for several hours or perhaps overnight. The supernatant from the original precipitation is saved and evaporated to a syrup or until dry. It too is dissolved in a minimum amount of warm acetone; typically about 100-120 mL of warm acetone. The total amount or acetone used for the two recrystallizations is usually approximately 200 mL. As before, an amount of warm methanol equal to four times the amount of acetone is added. The solution is cooled; crystallization begins almost at once but is allowed to continue several hours to overnight. The recrystallizations are quite efficient, but the product from the reaction supernatant is usually not quite as pure and is purified by recrystallization. The yield is approximately 85%. (mp 191-193° C.) 1H NMR (DMSO-d6) δ: 11.83 (s, 1H), 8.18 (d, J=8.5 Hz, 2H), 7.84 (br s, 1H), 7.64 (d, J=8.5 Hz, 2H), 7.25 (d, J=8.8 Hz), 6.96 (s, 1H), 4.56 (t, J=6 Hz, 2H), 4.00 (t, J=8.8 Hz, 2H), 3.21 (m, 4H), 1.51 (s, 9H). Combustion Analysis: Found: C, 63.16%; H, 5.56%; N, 9.45%. Calculated for 0.4 mole added water: C, 62.8%; H, 5.7%; N, 9.16%.

후처리

  1. customare placed into an argon filled flask
  2. customThen a dropping funnel is placed atop the flask (flushed with argon) and a water bath (
  3. temperatureto cool the flask)
  4. additionThis solution is added to the dropping funnel
  5. waitto proceed for an hour, at which time
  6. customOften, especially if the reactants are not entirely dry
  7. additionThese can be added neat to the stirred solution
  8. customto react another hour
  9. customafter which another TLC analysis usually reveals complete reaction
  10. customThe product usually precipitates out in part
  11. customthis is collected
  12. filtrationbt filtration
  13. washwashed with methanol
  14. customrecrystallized
  15. dissolutionby dissolving in a minimum amount (typically, 80-100 ml) of warm acetone
  16. additionadding four times that volume of warm methanol
  17. customThe supernatant from the original precipitation
  18. customevaporated to a syrup
  19. customuntil dry
  20. dissolutionIt too is dissolved in a minimum amount of warm acetone
  21. customThe total amount or acetone used for the two recrystallizations
  22. additionAs before, an amount of warm methanol equal to four times the amount of acetone is added
  23. temperatureThe solution is cooled
  24. customcrystallization
  25. waitto continue several hours to overnight
  26. customThe recrystallizations
  27. customis purified by recrystallization
  28. additionCalculated for 0.4 mole added water

출처 및 근거

ORD 기록
ord-3dbf39d985244aa1a3ce8bc317fb0a29
출처 데이터셋
uspto-grants-2004_04
DOI
10.6084/m9.figshare.5104873.v1
특허 번호
US06727356B1

반응 노트

이 페이지에서참가 물질반응 조건실험 절차후처리출처 및 근거반응 노트