홈MCP워크벤치Skills
홈워크벤치알림마이페이지
llms.txt · MCP 가이드개인정보처리방침 · 이용약관 · 지원v1.8.3
  1. 홈
  2. /반응

Sodium Carbonate → 4-Chloro-6-(2,5-dimethylphenyl)pyrimidine

HRID 2174173
인쇄

반응식

HRID 2174173 반응식
[Cl:1][C:2]1[CH:7]=[C:6](Cl)[N:5]=[CH:4][N:3]=1.[CH3:9][C:10]1[CH:15]=[CH:14][C:13]([CH3:16])=[CH:12][C:11]=1B(O)O.C(=O)([O-])[O-].[Na+].[Na+]>C1C=CC(P(C2C=CC=CC=2)C2C=CC=CC=2)=CC=1.C1C=CC(P(C2C=CC=CC=2)C2C=CC=CC=2)=CC=1.Cl[Pd]Cl.O.C(#N)C>[Cl:1][C:2]1[CH:7]=[C:6]([C:11]2[CH:12]=[C:13]([CH3:16])[CH:14]=[CH:15][C:10]=2[CH3:9])[N:5]=[CH:4][N:3]=1
참가 물질실험 절차후처리출처 및 근거반응 노트

참가 물질

8

반응물 3

HCID 10340Sodium Carbonate2회HCID 709434,6-DichloropyrimidineHCID 2734347(2,5-Dimethylphenyl)boronic acid2회

생성물 1

HCID 249022254-Chloro-6-(2,5-dimethylphenyl)pyrimidine수율 64%

시약·촉매·용매 4

HCID 6102075Dichlorobis(triphenylphosphine)palladium촉매
HCID 178418476
HCID 178418476, 화합물
촉매
HCID 962Water용매2회
HCID 6342Acetonitrile용매

실험 절차

First, 4.97 g of 4,6-dichloropyrimidine, 5.02 g of 2,5-dimethylphenylboronic acid, 3.55 g of sodium carbonate, 0.29 g of bis(triphenylphosphine)palladium(II)dichloride (abbreviation: Pd(PPh3)2Cl2), 20 mL of water, and 20 mL of acetonitrile were put in a recovery flask equipped with a reflux pipe, and the air in the flask was replaced with argon. This reaction container was heated by being irradiated with microwaves (2.45 GHz, 100 W) for 30 minutes. Further, 1.25 g of 2,5-dimethylphenylboronic acid, 0.89 g of sodium carbonate, and 0.073 g of Pd(PPh3)2Cl2 were put in the flask, and the reaction container was heated again by being irradiated with microwaves (2.45 GHz, 100 W) for 30 minutes. Then, water was added to this solution and an organic layer was extracted with dichloromethane. The obtained organic layer was washed with water and saturated brine, and was dried with magnesium sulfate. After the drying, the solution was filtered. The solvent of this solution was distilled off, and then the obtained residue was purified by flash column chromatography using hexane and ethyl acetate in a ratio of 5:1 as a developing solvent, so that the target pyrimidine derivative was obtained (pale yellow oily substance, yield of 64%). A synthetic scheme of Step 1 is shown in (d−1) below.

후처리

  1. customequipped with a reflux pipe
  2. temperatureThis reaction container was heated
  3. customby being irradiated with microwaves (2.45 GHz, 100 W) for 30 minutes
  4. temperaturethe reaction container was heated again
  5. customby being irradiated with microwaves (2.45 GHz, 100 W) for 30 minutes
  6. extractionan organic layer was extracted with dichloromethane
  7. washThe obtained organic layer was washed with water and saturated brine
  8. dry with materialwas dried with magnesium sulfate
  9. filtrationAfter the drying, the solution was filtered
  10. distillationThe solvent of this solution was distilled off
  11. customthe obtained residue was purified by flash column chromatography

출처 및 근거

ORD 기록
ord-addeae44c9f84df282faff19d92e62a5
출처 데이터셋
uspto-grants-2015_06
DOI
10.6084/m9.figshare.5104873.v1
특허 번호
US09059414B2

반응 노트

이 페이지에서참가 물질실험 절차후처리출처 및 근거반응 노트