Citric Acid → Tricalcium Citrate

HRID 256506

반응식

HRID 256506 반응식
[C:1]([OH:13])(=[O:12])[CH2:2][C:3]([CH2:8][C:9]([OH:11])=[O:10])([C:5]([OH:7])=[O:6])[OH:4].[OH-].[Ca+2:15].[OH-]>O>[C:1]([O-:13])(=[O:12])[CH2:2][C:3]([CH2:8][C:9]([O-:11])=[O:10])([C:5]([O-:7])=[O:6])[OH:4].[Ca+2:15].[C:1]([O-:13])(=[O:12])[CH2:2][C:3]([CH2:8][C:9]([O-:11])=[O:10])([C:5]([O-:7])=[O:6])[OH:4].[Ca+2:15].[Ca+2:15]

참가 물질

4

반응물 2

HCID 311Citric Acid4회HCID 6093208Calcium Hydroxide4회

생성물 1

HCID 13136Tricalcium Citrate

시약·촉매·용매 1

HCID 962Water용매4회

반응 조건

온도
134 fahrenheit

실험 절차

A calcium citrate sample was prepared by reacting 2763.8 lbs. of citric acid with 1600 lbs. calcium hydroxide (97-98% Ca(OH)2 by analysis) in the presence of 1433 gallons of water. The mole ratio of calcium hydroxide to citric acid was very slightly less than 3:2, actually 2.92:2. The citric acid (Pfizer fine granular, food grade) was mixed in a large batch tank with 675 gallons of cold water. The calcium hydroxide (Mississippi lime, hydrated lime, food code) was mixed in a separate batch tank with 75 gallons of cold water. The calcium hydroxide slurry is then pumped into the citric acid solution at a rate to deliver the entire slurry in 10-15 minutes. It is necessary to have good agitation during the entire reaction and mixing process. The remaining 83 gallons of water is used to rinse the calcium hydroxide tank and transport lines. Due to the heat of reaction, the temperature of the resultant slurry was increased from an initial value of 15° C. (60° F.) to a maximum of 57° C. (134° F.). After the reaction is complete, the batch is cooled to 80°-90° F. The final pH of this concentrated slurry (22% calcium citrate, dry basis) should fall within the range 3.8-4.6 or can be adjusted up or down using the reacting ingredients. The slurry is then dried via spray drying utilizing a rotary wheel (7600 rpm). The outlet temperature was adjusted to 225° F. and the inlet temperature was 450° F.

후처리

  1. customin 10-15 minutes
  2. customduring the entire reaction
  3. additionmixing process
  4. washto rinse the calcium hydroxide tank and transport lines
  5. temperatureDue to the heat of reaction
  6. temperaturethe batch is cooled to 80°-90° F
  7. dry with materialThe final pH of this concentrated slurry (22% calcium citrate, dry basis)
  8. customThe slurry is then dried via spray
  9. customdrying
  10. customwas adjusted to 225° F.
  11. customwas 450° F.

출처 및 근거

ORD 기록
ord-50aa8777219c4a809880484767cbaed3
출처 데이터셋
uspto-grants-1993_11
특허 번호
US05258190

연결된 노트

불러오는 중…