홈MCP워크벤치Skills
홈워크벤치알림마이페이지
llms.txt · MCP 가이드개인정보처리방침 · 이용약관 · 지원v1.8.3
  1. 홈
  2. /반응

M-Cresol → 2-Hydroxy-4-methylbenzaldehyde

HRID 257348
인쇄

반응식

HRID 257348 반응식
C([Mg]Br)C.[CH:5]1[C:10]([OH:11])=[CH:9][CH:8]=[CH:7][C:6]=1[CH3:12].[CH2:13]=[O:14].CN(C)P(N(C)C)(N(C)C)=O>O1CCCC1.C1(C)C=CC=CC=1.C(OCC)C>[CH3:12][C:6]1[CH:5]=[C:10]([OH:11])[C:9](=[CH:8][CH:7]=1)[CH:13]=[O:14]
참가 물질실험 절차후처리출처 및 근거반응 노트

참가 물질

8

반응물 4

HCID 342M-CresolHCID 712FormaldehydeHCID 12679HexamethylphosphoramideHCID 178418443HCID 178418443, 화합물

생성물 1

HCID 612002-Hydroxy-4-methylbenzaldehyde수율 46.3%

시약·촉매·용매 3

HCID 1140Toluene용매
HCID 3283
Diethyl Ether
용매
HCID 8028Tetrahydrofuran용매

실험 절차

A 1M solution of ethylmagnesium bromide in tetrahydrofuran (100 ml) was cooled to 15° C., and a solution of 10.81 g (0.100 mole) of m-cresol was added during a 45 minute period while the temperature was held at 15° C. Upon completion of the addition, the mixture was stirred at room temperature for 30 minutes, and then a mixture of 7.5 g (0.25 mole) of paraformaldehyde and 17.92 g (0.100 mole) of hexamethylphosphoramide in 200 mL of toluene was added in one portion. The resulting solution was heated at 80° C. for approximately seventeen hours, after which the solvent was evaporated under reduced pressure, leaving a yellow residue. This residue was dissolved in diethyl ether, and this solution was extracted with 50 mL of hydrochloric acid and 100 mL of water. The organic phase was separated, washed with water, and dried over anhydrous magnesium sulfate. After filtration the solution was evaporated under reduced pressure, leaving an orange solid as a residue. This solid was placed on a silica gel column and eluted with methylene chloride/petroleum ether (50/50). Evaporation of the solvents yielded 6.30 g of 4-methylsalicylaldehyde as a yellow solid, m.p. 51°-53° C. The NMR and IR spectra were consistent with the proposed structure.

후처리

  1. customwas held at 15° C
  2. additionUpon completion of the addition
  3. additionwas added in one portion
  4. temperatureThe resulting solution was heated at 80° C. for approximately seventeen hours
  5. customafter which the solvent was evaporated under reduced pressure
  6. customleaving a yellow residue
  7. extractionthis solution was extracted with 50 mL of hydrochloric acid and 100 mL of water
  8. customThe organic phase was separated
  9. washwashed with water
  10. dry with materialdried over anhydrous magnesium sulfate
  11. filtrationAfter filtration the solution
  12. customwas evaporated under reduced pressure
  13. customleaving an orange solid as a residue
  14. washeluted with methylene chloride/petroleum ether (50/50)
  15. customEvaporation of the solvents

출처 및 근거

ORD 기록
ord-b3aa8d4c6b70478ba1e3adf0a5cf9b5b
출처 데이터셋
uspto-grants-1993_11
DOI
10.6084/m9.figshare.5104873.v1
특허 번호
US05262390

반응 노트

이 페이지에서참가 물질실험 절차후처리출처 및 근거반응 노트