홈MCP워크벤치Skills
홈워크벤치알림마이페이지
llms.txt · MCP 가이드개인정보처리방침 · 이용약관 · 지원v1.8.2
  1. 홈
  2. /반응

Acetic Acid → Cobalt diacetate

HRID 351341
인쇄

반응식

HRID 351341 반응식
O=O.[CH-]=O.[CH-]=O.[C-]#[O+].[C-]#[O+].[C-]#[O+].[C-]#[O+].[C-]#[O+].[C-]#[O+].[Co:19].[Co+2].[C:21]([OH:24])(=[O:23])[CH3:22]>>[C:21]([O-:24])(=[O:23])[CH3:22].[Co+2:19].[C:21]([O-:24])(=[O:23])[CH3:22]
참가 물질실험 절차후처리출처 및 근거반응 노트

참가 물질

4

반응물 3

HCID 176Acetic AcidHCID 977OxygenHCID 25049Dicobalt Octacarbonyl (stabilized with 1-5% Hexane)

생성물 1

HCID 6277Cobalt diacetate

실험 절차

The C12–C14 α-olefin mixture from Example 1 with the composition shown in Table I was hydroformylated in the manner indicated in Example 1. Unlike Example 1, instead of the rhodium catalyst and the polyethyleneimine ligand, the hydroformylation catalyst used was dicobaltoctacarbonyl without any other ligand, the amount being 2 g of cobalt based on 1000 g of reactor contents. In order that the olefin conversion obtained was from 98 to 99%, as in Example 1, using the same olefin feed, a reactor temperature of 140° C. was required in both reactors. The (aldehyde+alcohol) selectivity was 94%, the paraffin selectivity was 3%, and the selectivity to give higher-boiling aldehyde condensation products was 3%. Once the pressure in the reactors had been released, the discharge was treated with aqueous acetic acid solution while introducing atmospheric oxygen, until the cobalt carbonyl had been oxidized to give cobalt acetate. The aqueous, cobalt-containing phase was separated off in a phase separator, and the organic phase, as in Example 1, hydrogenated and distilled. Table III gives the composition of the C13–C15 alcohol mixture.

후처리

  1. customthe selectivity to give higher-boiling

출처 및 근거

ORD 기록
ord-80d027c7138b40e293517e0cfe76fcbe
출처 데이터셋
uspto-grants-2007_02
DOI
10.6084/m9.figshare.5104873.v1
특허 번호
US07183446B2

반응 노트

이 페이지에서참가 물질실험 절차후처리출처 및 근거반응 노트