홈MCP워크벤치Skills
홈워크벤치알림마이페이지
llms.txt · MCP 가이드개인정보처리방침 · 이용약관 · 지원v1.8.3
  1. 홈
  2. /반응

Tetrahydrofuran → 4-Hexylanisole

HRID 382079
인쇄

반응식

HRID 382079 반응식
C=CCCCC.B1[CH:12]2[CH2:13][CH2:14][CH2:15][CH:8]1[CH2:9][CH2:10][CH2:11]2.C1COCC1.ClC1C=[CH:26][C:25]([O:28][CH3:29])=[CH:24][CH:23]=1.[F-].[Cs+]>C([O-])(=O)C.[Pd+2].C([O-])(=O)C.CC1C=CC(C)=CC=1C1C=CC=C(C)C=1>[CH2:11]([C:10]1[CH:9]=[CH:26][C:25]([O:28][CH3:29])=[CH:24][CH:23]=1)[CH2:12][CH2:13][CH2:14][CH2:15][CH3:8]
참가 물질반응 조건실험 절차후처리출처 및 근거반응 노트

참가 물질

8

반응물 5

HCID 8028TetrahydrofuranHCID 115971-HexeneHCID 121674-ChloroanisoleHCID 25953Cesium fluorideHCID 789669-Borabicyclo(3.3.1)nonane

생성물 1

HCID 5785994-Hexylanisole수율 89%

시약·촉매·용매 2

HCID 167845
palladium(II) acetate
촉매
HCID 110416892,3',5-Trimethyl-1,1'-biphenyl촉매

반응 조건

온도
0 °C

실험 절차

An oven-dried resealable Schlenk tube was capped with a rubber septum, cooled under an argon purge, charged with 1-hexene (0.19 mL, 1.5 mmol), and cooled to 0° C. A solution of 9-BBN in THF (3 mL, 1.5 mmol, 0.5 M) was added, the flask was stirred at 0° C. for 15 min, then warmed to room temperature and stirred for 5 h. 4-Chloroanisole (0.12 mL, 1.0 mmol) was added, the septum was removed, and palladium acetate (4.4 mg, 0.02 mmol, 2 mol %), ligand 2 (11.9 mg, 0.03 mmol, 3 mol %), and cesium fluoride (456 mg, 3.0 mmol) were added under a stream of argon. The septum was replaced and the flask was purged with argon for 30 s. Dioxane (2 mL) was added, the septum was removed, the tube was sealed with a teflon screw cap, and the mixture was stirred at rt for 2 min. The reaction mixture was then heated to 50° C. with stirring for 22 h, at which time GC analysis showed the aryl chloride had been completely consumed. The mixture was cooled to room temperature, diluted with ether (20 mL), and poured into a separatory funnel. The mixture was washed with 1 M aqueous NaOH (20 mL), the layers were separated, and the aqueous phase was extracted with ether (20 mL). The combined organic layers were dried over anhydrous magnesium sulfate, filtered, and concentrated in vacuo. The crude material was purified by flash chromatography to afford 170 mg (89%) of a colorless oil: 1H NMR (300 MHz, CDCl3) δ 7.09 (d, 2H, J=8.8 Hz), 6.82 (d, 2H, J=8.6 Hz), 3.78 (s, 3H), 2.54 (t, 2H, J=7.5 Hz), 1.54-1.60 (m, 2H), 1.28-1.35 (m, 6H), 0.88 (t, 3H, J=6.8 Hz); 13C NMR (125 MHz, CDCl3) δ 157.6, 135.0, 129.2, 113.6, 55.2, 35.0, 31.73, 31.70, 28.9, 22.6, 14.1; IR (neat, cm−1) 2926, 1513, 1243, 1038, 822. Anal Calcd for C13H20O: C, 81.20; 11, 10.48. Found: C, 81.19; H, 10.62.

후처리

  1. customAn oven-dried resealable Schlenk tube was capped with a rubber septum
  2. temperaturecooled under an argon
  3. custompurge
  4. temperaturewarmed to room temperature
  5. stirringstirred for 5 h
  6. customthe septum was removed
  7. customthe flask was purged with argon for 30 s
  8. additionDioxane (2 mL) was added
  9. customthe septum was removed
  10. customthe tube was sealed with a teflon
  11. customscrew cap
  12. stirringthe mixture was stirred at rt for 2 min
  13. temperatureThe reaction mixture was then heated to 50° C.
  14. stirringwith stirring for 22 h, at which time GC analysis
  15. customhad been completely consumed
  16. temperatureThe mixture was cooled to room temperature
  17. additiondiluted with ether (20 mL)
  18. additionpoured into a separatory funnel
  19. washThe mixture was washed with 1 M aqueous NaOH (20 mL)
  20. customthe layers were separated
  21. extractionthe aqueous phase was extracted with ether (20 mL)
  22. dry with materialThe combined organic layers were dried over anhydrous magnesium sulfate
  23. filtrationfiltered
  24. concentrationconcentrated in vacuo
  25. customThe crude material was purified by flash chromatography

출처 및 근거

ORD 기록
ord-033cec98096f4f76a40a05f76f102297
출처 데이터셋
uspto-grants-2001_10
DOI
10.6084/m9.figshare.5104873.v1
특허 번호
US06307087B1

반응 노트

이 페이지에서참가 물질반응 조건실험 절차후처리출처 및 근거반응 노트