홈MCP워크벤치Skills
홈워크벤치알림마이페이지
llms.txt · MCP 가이드개인정보처리방침 · 이용약관 · 지원v1.8.3
  1. 홈
  2. /반응

Lauric Acid → 12-Tricosanone

HRID 399260
인쇄

반응식

HRID 399260 반응식
[C:1]([OH:14])(=O)[CH2:2][CH2:3][CH2:4][CH2:5][CH2:6][CH2:7][CH2:8][CH2:9][CH2:10][CH2:11][CH3:12].[O-2].[Mg+2]>CCCCCC>[CH3:11][CH2:10][CH2:9][CH2:8][CH2:7][CH2:6][CH2:5][CH2:4][CH2:3][CH2:2][CH2:1][C:1](=[O:14])[CH2:2][CH2:3][CH2:4][CH2:5][CH2:6][CH2:7][CH2:8][CH2:9][CH2:10][CH2:11][CH3:12]
참가 물질실험 절차후처리출처 및 근거반응 노트

참가 물질

4

반응물 2

HCID 3893Lauric AcidHCID 6850729Magnesium monoxide

생성물 1

HCID 1088812-Tricosanone수율 77.7%

시약·촉매·용매 1

HCID 8058Hexane용매2회

실험 절차

Lauric acid (50 g, 0.25 mol) and magnesium oxide (12.6 g, 0.3125 mol) were charged in a 500 ml round bottom flask equipped with an air condenser having a length of 50 cm, and then the mixture was heated at 300° to 320° C. for 8 hours using a heating mantle. After the completion of the reaction, the reaction solution was cooled. Then, 250-300 ml of n-hexane was added and the reaction solution was sufficiently dissolved in n-hexane with heating. The resulting solution was filtered in a hot state and about 200 ml of an aqueous 4N-sulfuric acid solution was added to the filtrate, followed by sufficiently stirring to decompose unreacted magnesium laurate. The hexane layer was separated, washed with water, and then washed with 200 ml of an aqueous 5% NaOH solution to remove dissolved lauric acid. The hexane layer was washed again with water, dried over anhydrous sodium sulfate and filtered, and then hexane was removed by using a rotary evaporator to isolate a reaction product. The resulting product was recrystallized from a mixed solvent of ethanol and benzene in the ratio of 2:1 to obtain 32.9 g of 12-tricosanone as a white flakelike crystal (yield 77.8%).

후처리

  1. customequipped with an air condenser
  2. temperaturethe mixture was heated at 300° to 320° C. for 8 hours
  3. customAfter the completion of the reaction
  4. temperaturethe reaction solution was cooled
  5. temperaturewith heating
  6. filtrationThe resulting solution was filtered in a hot state and about 200 ml of an aqueous 4N-sulfuric acid solution
  7. additionwas added to the filtrate
  8. customThe hexane layer was separated
  9. washwashed with water
  10. washwashed with 200 ml of an aqueous 5% NaOH solution
  11. customto remove
  12. dissolutiondissolved lauric acid
  13. washThe hexane layer was washed again with water
  14. dry with materialdried over anhydrous sodium sulfate
  15. filtrationfiltered
  16. customhexane was removed
  17. customa rotary evaporator
  18. customto isolate a reaction product
  19. customThe resulting product was recrystallized from a mixed solvent of ethanol and benzene in the ratio of 2:1

출처 및 근거

ORD 기록
ord-dce1e0e9c3254424b833635ee9d8f6f5
출처 데이터셋
uspto-grants-1998_10
DOI
10.6084/m9.figshare.5104873.v1
특허 번호
US05817839

반응 노트

이 페이지에서참가 물질실험 절차후처리출처 및 근거반응 노트