홈MCP워크벤치Skills
홈워크벤치알림마이페이지
llms.txt · MCP 가이드개인정보처리방침 · 이용약관 · 지원v1.8.3
  1. 홈
  2. /반응

Dibutyl maleate → Gamma-Butyrolactone

HRID 437735
인쇄

반응식

HRID 437735 반응식
[C:1]([O:12][CH2:13][CH2:14][CH2:15]C)(=[O:11])/[CH:2]=[CH:3]\[C:4](OCCCC)=[O:5].[H][H]>[Cr]([O-])([O-])=O.[Cu+2].O>[CH2:1]([OH:11])[CH2:2][CH2:3][CH2:4][OH:5].[C:1]1(=[O:11])[O:12][CH2:13][CH2:14][CH2:15]1
참가 물질반응 조건실험 절차후처리출처 및 근거반응 노트

참가 물질

6

반응물 2

HCID 5271569Dibutyl maleateHCID 178418361HCID 178418361, 화합물3회

생성물 2

HCID 7302Gamma-ButyrolactoneHCID 80641,4-Butanediol

시약·촉매·용매 2

HCID 178505374HCID 178505374, 화합물촉매HCID 962Water용매

반응 조건

온도
250 °C

실험 절차

Into a 1 liter magnedrive stirred autoclave was placed 200 g. of dibutyl maleate (reagent grade, Matheson Coleman and Bell) and 30 g. of copper chromite hydrogenation catalyst (Calsicat PC 108-80, Mallinckrodt Chemical Works). The autoclave was charged and pressured to 2,900 psig with hydrogen. Heat was then applied and the temperature was slowly brought to approximately 100° C. at which point an exothermic reaction ensued at a temperature increase to 250° C. Cooling water was passed through the internal coils of the autoclave to control the temperature and not to permit it to exceed about 250° C. After about 5 to 10 minutes the internal temperature had returned to approximately 120° C. and the contents of the autoclave were again heated to a temperature of 200° C. and maintained at this temperature and a hydrogen partial pressure of 2,900 psig for a period of 2.5 hours at which time the reaction appeared to be complete. The contents of the autoclave were then cooled and the hydrogen partial pressure was vented to the atmosphere. The catalyst was separated from the liquid autoclave contents by filtration and the filter was washed with n-butanol. Distillation of the filtrate yielded 1,4-butanediol containing a trace of γ-butyrolactone. Analysis of the filtrate by gas-liquid partition chromatographic techniques indicated that 99% of the dibutyl maleate had been converted to products and that the selectivity to 1,4-butanediol was 90%.

후처리

  1. additionThe autoclave was charged
  2. temperatureHeat
  3. customwas slowly brought to approximately 100° C. at which point
  4. customan exothermic reaction
  5. customto exceed about 250° C
  6. temperaturethe contents of the autoclave were again heated to a temperature of 200° C.
  7. temperaturemaintained at this temperature
  8. temperatureThe contents of the autoclave were then cooled
  9. customThe catalyst was separated from the liquid autoclave contents by filtration
  10. washthe filter was washed with n-butanol
  11. distillationDistillation of the filtrate

출처 및 근거

ORD 기록
ord-91e2745a9fa94781bdd1439468befe17
출처 데이터셋
uspto-grants-1977_06
DOI
10.6084/m9.figshare.5104873.v1
특허 번호
US04032458

반응 노트

이 페이지에서참가 물질반응 조건실험 절차후처리출처 및 근거반응 노트