홈MCP워크벤치Skills
홈워크벤치알림마이페이지
llms.txt · MCP 가이드개인정보처리방침 · 이용약관 · 지원v1.8.3
  1. 홈
  2. /반응

Thiophenol → 5-Phenylthio-2-(2-hydroxy-3,5-di-tert-butylphenyl)-2H-benzotriazole

HRID 440188
인쇄

반응식

HRID 440188 반응식
Cl[C:2]1[CH:25]=[CH:24][C:5]2=[N:6][N:7]([C:9]3[CH:14]=[C:13]([C:15]([CH3:18])([CH3:17])[CH3:16])[CH:12]=[C:11]([C:19]([CH3:22])([CH3:21])[CH3:20])[C:10]=3[OH:23])[N:8]=[C:4]2[CH:3]=1.[C:26]1([SH:32])[CH:31]=[CH:30][CH:29]=[CH:28][CH:27]=1.[OH-].[Na+]>CN(C)C=O>[C:26]1([S:32][C:2]2[CH:25]=[CH:24][C:5]3=[N:6][N:7]([C:9]4[CH:14]=[C:13]([C:15]([CH3:18])([CH3:17])[CH3:16])[CH:12]=[C:11]([C:19]([CH3:22])([CH3:21])[CH3:20])[C:10]=4[OH:23])[N:8]=[C:4]3[CH:3]=2)[CH:31]=[CH:30][CH:29]=[CH:28][CH:27]=1
참가 물질반응 조건실험 절차후처리출처 및 근거반응 노트

참가 물질

5

반응물 3

HCID 7969ThiophenolHCID 14798Sodium HydroxideHCID 774702,4-Di-tert-butyl-6-(5-chloro-2H-benzotriazol-2-yl)phenol

생성물 1

HCID 193491505-Phenylthio-2-(2-hydroxy-3,5-di-tert-butylphenyl)-2H-benzotriazole

시약·촉매·용매 1

HCID 6228Dimethylformamide용매

반응 조건

온도
80 °C

실험 절차

Into a two-liter three-necked flask equipped with stirrer, thermometer, distillation set-up and nitrogen supply are charged 268.4 g (0.75 mole) of 5-chloro-2-(2-hydroxy-3,5-di-tert-butylphenyl)-2H-benzotriazole, 93.7 g (0.825 mole) of thiophenol and 400 mL of N,N-dimethylformamide (DMF). The reactor is evacuated and filled with nitrogen three times to establish an inert atmosphere. To the slurry is added 66.0 g (0.825 mole) of 50% aqueous sodium hydroxide solution and the mixture heated to reflux. At this point water distills off as an azeotrope until the head-temperature reaches 132° C. and a reaction temperature of 150° C. After 18 hours there is no residual starting benzotriazole compound observed (TLC). At reduced pressure most of the DMF is distilled off at 80° C. To the residue is then charged 500 mL of toluene and 200 mL of water. After slow stirring for a few minutes at 80° C. the lower aqueous phase is drained off. The addition of 200 mL of water is repeated twice more, the second time with addition of 1 mL of acetic acid. Any residual water is azeotroped off until a clear solution is obtained. Approximately 300 mL of toluene is removed under partial vacuum at 90° C. and to the concentrate is added 800 mL of isopropanol, resulting in rapid crystallization. The reaction mixture is cooled to 2020 C. and filtered. The light yellow crystals are washed with 250 ml of isopropanol and dried to give 317 g (97.9% of theory) of the title compound, mp. 132°-134° C.

후처리

  1. customInto a two-liter three-necked flask equipped with stirrer
  2. distillationthermometer, distillation set-up and nitrogen
  3. customThe reactor is evacuated
  4. additionfilled with nitrogen three times
  5. temperaturethe mixture heated to reflux
  6. distillationAt this point water distills off as an azeotrope until the head-temperature reaches 132° C.
  7. customa reaction temperature of 150° C
  8. distillationAt reduced pressure most of the DMF is distilled off at 80° C
  9. additionTo the residue is then charged 500 mL of toluene and 200 mL of water
  10. additionThe addition of 200 mL of water
  11. additionthe second time with addition of 1 mL of acetic acid
  12. customAny residual water is azeotroped off until a clear solution
  13. customis obtained
  14. customApproximately 300 mL of toluene is removed under partial vacuum at 90° C. and to the concentrate
  15. additionis added 800 mL of isopropanol
  16. customresulting in rapid crystallization
  17. temperatureThe reaction mixture is cooled to 2020 C
  18. filtrationand filtered
  19. washThe light yellow crystals are washed with 250 ml of isopropanol
  20. customdried

출처 및 근거

ORD 기록
ord-f0796d6bc67848c5802820b62fc9c0a1
출처 데이터셋
uspto-grants-1996_05
DOI
10.6084/m9.figshare.5104873.v1
특허 번호
US05516914

반응 노트

이 페이지에서참가 물질반응 조건실험 절차후처리출처 및 근거반응 노트