홈MCP워크벤치Skills
홈워크벤치알림마이페이지
llms.txt · MCP 가이드개인정보처리방침 · 이용약관 · 지원v1.8.3
  1. 홈
  2. /반응

Acetic Acid → 2-Fluoro-4-isopropoxyaniline

HRID 482409
인쇄

반응식

HRID 482409 반응식
C(O)(=O)C.[CH:5]([O:8][C:9]1[CH:14]=[CH:13][C:12]([N+:15]([O-])=O)=[C:11]([F:18])[CH:10]=1)([CH3:7])[CH3:6].C(N)(=O)C>O.C(OCC)C.[Fe]>[CH:5]([O:8][C:9]1[CH:14]=[CH:13][C:12]([NH2:15])=[C:11]([F:18])[CH:10]=1)([CH3:7])[CH3:6]
참가 물질실험 절차후처리출처 및 근거반응 노트

참가 물질

7

반응물 3

HCID 176Acetic AcidHCID 178AcetamideHCID 135386522-Fluoro-4-isopropoxy-1-nitrobenzene

생성물 1

HCID 37563842-Fluoro-4-isopropoxyaniline

시약·촉매·용매 3

HCID 23925Iron촉매HCID 962Water용매
HCID 3283
Diethyl Ether
용매

실험 절차

A stirred flask containing 350 mL of acetic acid was heated to 80°-85° C. under a nitrogen atmosphere. To this flask was added 39.10 g (0.700 mole) of powdered iron, and this mixture was stirred for one hour. A solution of 4-isopropoxy-2-fluoronitrobenzene in 250 mL was added to the mixture dropwise. Upon completion of addition, the reaction mixture was heated at 80°-85° C. for one hour. After being cooled below 40° C., the mixture was filtered, and the solvent was evaporated under reduced pressure, leaving a residue. This residue was dissolved in a mixture of water and diethyl ether. The organic layer was separated and was washed in succession with saturated aqueous solutions of sodium bicarbonate and sodium chloride. It was then dried over anhydrous magnesium sulfate, filtered through a short column of silica gel, and the solvent was evaporated under reduced pressure, leaving an impure residue which contained significant amounts of acetamide in addition to the desired product. This residue was suspended in 500 mL of 2N hydrochloric acid for one hour. The hydrochloric acid mixture was then extracted with diethyl ether, and the two phases were separated. Aqueous sodium hydroxide solution was added to the aqueous hydrochloride solution until it was basic. This basic solution was extracted with diethyl ether, and the extract was dried over anhydrous magnesium sulfate and filtered. After evaporation of the solvent under reduced pressure, the residue was recrystallized from diethyl ether/petroleum ether to yield 16.90 g of 4-isopropoxy-2-fluoroaniline as an oil, which darkened on standing. The NMR spectrum was consistent with the proposed structure.

후처리

  1. temperaturewas heated to 80°-85° C. under a nitrogen atmosphere
  2. additionUpon completion of addition
  3. temperaturethe reaction mixture was heated at 80°-85° C. for one hour
  4. temperatureAfter being cooled below 40° C.
  5. filtrationthe mixture was filtered
  6. customthe solvent was evaporated under reduced pressure
  7. customleaving a residue
  8. customThe organic layer was separated
  9. washwas washed in succession with saturated aqueous solutions of sodium bicarbonate and sodium chloride
  10. dry with materialIt was then dried over anhydrous magnesium sulfate
  11. filtrationfiltered through a short column of silica gel
  12. customthe solvent was evaporated under reduced pressure
  13. customleaving an impure residue which

출처 및 근거

ORD 기록
ord-e8a576288f664d188712006d507479ff
출처 데이터셋
uspto-grants-1998_08
DOI
10.6084/m9.figshare.5104873.v1
특허 번호
US05798316

반응 노트

이 페이지에서참가 물질실험 절차후처리출처 및 근거반응 노트