홈MCP워크벤치Skills
홈워크벤치알림마이페이지
llms.txt · MCP 가이드개인정보처리방침 · 이용약관 · 지원v1.8.3
  1. 홈
  2. /반응

Cesium fluoride → N-[6-(3-pyridyl)-1-[[2-(trimethylsilyl)ethoxy]methyl]-1H-indazol-3-yl]butanamide

HRID 497600
인쇄

반응식

HRID 497600 반응식
C(B(CC)[C:4]1[CH:5]=[N:6][CH:7]=[CH:8][CH:9]=1)C.[F-].[Cs+].Cl[C:15]1[CH:23]=[C:22]2[C:18]([C:19]([NH:32][C:33](=[O:37])[CH2:34][CH2:35][CH3:36])=[N:20][N:21]2[CH2:24][O:25][CH2:26][CH2:27][Si:28]([CH3:31])([CH3:30])[CH3:29])=[CH:17][CH:16]=1>O1CCOCC1.C([O-])(=O)C.[Pd+2].C([O-])(=O)C>[N:6]1[CH:7]=[CH:8][CH:9]=[C:4]([C:15]2[CH:23]=[C:22]3[C:18]([C:19]([NH:32][C:33](=[O:37])[CH2:34][CH2:35][CH3:36])=[N:20][N:21]3[CH2:24][O:25][CH2:26][CH2:27][Si:28]([CH3:31])([CH3:29])[CH3:30])=[CH:17][CH:16]=2)[CH:5]=1
참가 물질반응 조건실험 절차후처리출처 및 근거반응 노트

참가 물질

6

반응물 3

HCID 25953Cesium fluorideHCID 6428513-(Diethylboryl)pyridineHCID 10406687N-[6-chloro-1-[[2-(trimethylsilyl)ethoxy)methyl]-1H-indazol-3-yl)butanamide

생성물 1

HCID 10386888N-[6-(3-pyridyl)-1-[[2-(trimethylsilyl)ethoxy]methyl]-1H-indazol-3-yl]butanamide

시약·촉매·용매 2

HCID 167845palladium(II) acetate촉매
HCID 31275
1,4-Dioxane
용매

반응 조건

온도
100 °C

실험 절차

900 mg of diethyl-3-pyridylborane, 1.86 g of caesium fluoride, 18.4 mg of palladium acetate and finally 48 mg of 2-dicyclohexylphosphine-2-(N,N-dimethylamino)biphenyl are added to 1.5 g of N-[6-chloro-1-[[2(trimethylsilyl)ethoxy]methyl]-1H-indazol-3-yl]butanamide, described previously, in 40 cm3 of dioxane. The mixture is then heated at about 100° C. for 17 hours and then filtered through a sinter funnel and evaporated under reduced pressure (2 kPa; 50° C.). The residue is taken up in 75 cm3 of ethyl acetate and 50 cm3 of distilled water. The organic phase is washed again with 50 cm3 of distilled water and with 50 cm3 of saturated aqueous sodium chloride solution. The organic phase is dried over magnesium sulphate, filtered through a sinter funnel and then evaporated under reduced pressure under the conditions described previously. The residue is purified by chromatography under an argon pressure of 50 kPa, on a column of silica gel (particle size 40-60 μm; diameter 2.5 cm), eluting with a cyclohexane/ethyl acetate mixture (50/50 by volume) and collecting 25 cm3 fractions. The fractions containing the expected product are combined and evaporated under reduced pressure (2 kPa; 50° C.). After drying (90 Pa; 50° C.), 900 mg of N-[6-(3-pyridyl)-1-[[2-(trimethylsilyl)ethoxy]methyl]-1H-indazol-3-yl]butanamide are thus obtained in the form of a yellow oil.

후처리

  1. filtrationfiltered through a sinter funnel
  2. customevaporated under reduced pressure (2 kPa; 50° C.)
  3. washThe organic phase is washed again with 50 cm3 of distilled water and with 50 cm3 of saturated aqueous sodium chloride solution
  4. dry with materialThe organic phase is dried over magnesium sulphate
  5. filtrationfiltered through a sinter funnel
  6. customevaporated under reduced pressure under the conditions
  7. customThe residue is purified by chromatography under an argon pressure of 50 kPa
  8. washon a column of silica gel (particle size 40-60 μm; diameter 2.5 cm), eluting with a cyclohexane/ethyl acetate mixture (50/50 by volume)
  9. customcollecting 25 cm3 fractions
  10. additionThe fractions containing the expected product
  11. customevaporated under reduced pressure (2 kPa; 50° C.)
  12. dry with materialAfter drying (90 Pa; 50° C.), 900 mg of N-[6-(3-pyridyl)-1-[[2-(trimethylsilyl)ethoxy]methyl]-1H-indazol-3-yl]butanamide
  13. customare thus obtained in the form of a yellow oil

출처 및 근거

ORD 기록
ord-5fdba49861bb444a899ecd5b9126d7fb
출처 데이터셋
uspto-grants-2005_09
DOI
10.6084/m9.figshare.5104873.v1
특허 번호
US06949579B2

반응 노트

이 페이지에서참가 물질반응 조건실험 절차후처리출처 및 근거반응 노트