HRID1053999

反应详情

EQUATION

反应方程式

HRID 1053999 的结构方程式

AUXILIARIES

试剂、催化剂与溶剂

2

PROCEDURE

实验过程

Into a 100-mL three-neck flask were put 1.2 g (4.8 mmol) of 2-chlorodibenzo[f,h]quinoxaline, 2.1 g (4.7 mmol) of 3,5-bis(9H-carbazol-9-yl)phenylboronic acid, and the air in the flask was replaced with nitrogen. To this mixture were added 18 mL of toluene, 6.0 mL of ethanol, and 6.0 mL of an aqueous solution of potassium carbonate (2.0 mol/L). This mixture was stirred to be degassed while the pressure was reduced. To this mixture was added 0.11 g (0.096 mmol) of tetrakis(triphenylphosphine)palladium(0), and the mixture was stirred at 80° C. for six hours under a nitrogen stream, so that a solid was precipitated. The precipitated solid was collected by suction filtration. To the obtained solid was added about 100 mL of water, washed by ultrasonic wave irradiation, and subjected to suction filtration to obtain a solid. To the obtained solid was added about 100 mL of ethanol, washed by ultrasonic wave irradiation, and subjected to suction filtration to obtain a solid. The obtained solid was dissolved in about 1.5 L of hot toluene, and this solution was suction-filtered through Celite and Florisil. A solid obtained by concentration of the filtrate was washed with toluene, so that 2.8 g of a yellow solid, which was the object of the synthesis, was obtained in a yield of 94%. The synthesis scheme of Step 3 is shown in (a-3).

WORKUP

后处理

  1. customInto a 100-mL three-neck flask were put
  2. customto be degassed while the pressure
  3. stirringthe mixture was stirred at 80° C. for six hours under a nitrogen stream
  4. customso that a solid was precipitated
  5. filtrationThe precipitated solid was collected by suction filtration
  6. additionTo the obtained solid was added about 100 mL of water
  7. washwashed by ultrasonic wave irradiation
  8. filtrationsubjected to suction filtration
  9. customto obtain a solid
  10. washwashed by ultrasonic wave irradiation
  11. filtrationsubjected to suction filtration
  12. customto obtain a solid
  13. filtrationthis solution was suction-filtered through Celite and Florisil
  14. customA solid obtained by concentration of the filtrate
  15. washwas washed with toluene, so that 2.8 g of a yellow solid, which
  16. customthe object of the synthesis
  17. customwas obtained in a yield of 94%
  18. customThe synthesis scheme of Step 3