反应详情
EQUATION
反应方程式
REACTANTS
反应物
PRODUCTS
生成物
AUXILIARIES
试剂、催化剂与溶剂
CONDITIONS
反应条件
- 温度
- -70 °C
PROCEDURE
实验过程
The 4-ethylphenyloxazoline (2.03 g, 10 mmol) was dried in a vacuum oven at 60° C. for 2-3 hours, dissolved in 50 mL of dry THF, and charged to a 300 mL round bottom flask equipped with a thermometer, nitrogen inlet, and magnetic stir bar. The mixture was cooled under nitrogen to −70° C. in a dry ice/acetone bath. Butyl lithium in hexane (7.5 mL, 0.012 mmol) was added in two portions and warmed to −25° C. over 2 hours. The mixture was cooled again to −65° C. and N-fluorobenzenesulfonimide (3.79 g, 0.012 mmol) was added in three portions. The mixture was allowed to warm to room temperature and was stirred overnight. The reaction mixture was quenched with 100 mL of saturated NH4Cl, and transferred to a separatory funnel with ethyl ether washes. 25% NaOH was added slowly and mixed until an aqueous phase with pH=10 was achieved. The aqueous phase was extracted with ether and the ether was washed with a small volume of water. The ether extracts were dried over MgSO4 and evaporated to give 2.51 g of 2-(2- fluoro-4-ethyl-phenyl)-4,4-dimethyl-4,5-dihydro-oxazole as a brown bit. In a second experiment, a rate of 70% fluorination was achieved (highest) with a reactant ratio of 1:1.5:1.5 oxazoline:BuLi:N-fluorobenzenesulfonimide. 1NMR (300 MHz, CDCl3) δ (ppm): 7.0 (d, 2H), 7.78 (t, 1H), 4.1 (s, 2H), 2.7 (q, 2H), 2.7 (q, 2H), 1.39 (s, 6H), 1.2 (t, 3H).
WORKUP
后处理
- additioncharged to a 300 mL round bottom flask
- customequipped with a thermometer, nitrogen inlet, and magnetic stir bar
- temperaturewarmed to −25° C. over 2 hours
- temperatureThe mixture was cooled again to −65° C.
- temperatureto warm to room temperature
- customThe reaction mixture was quenched with 100 mL of saturated NH4Cl
- customtransferred to a separatory funnel with ethyl ether washes
- addition25% NaOH was added slowly
- additionmixed until an aqueous phase with pH=10
- extractionThe aqueous phase was extracted with ether
- washthe ether was washed with a small volume of water
- dry with materialThe ether extracts were dried over MgSO4
- customevaporated