反应详情

温度

100 °C

The title compound was prepared by these procedures using (1E,4E)-ethyl 8-bromo-2-(tert-butoxycarbonylamino)-3H-benzo[b]azepine-4-carboxylate and 4-(3-(9-borabicyclo[3.3.1]nonan-9-yl)propyl)morpholine. Preparation of 3-nitro-4′-(pyrrolidine-1-carbonyl)biphenyl-4-carbaldehyde, except in this case a co-solvent of EtOH/toluene/water (2:1:1) and Cs2CO3 were used: To a solution of 4-bromo-2-nitrobenzaldehyde (20.2 g, 87.9 mmol), 4-(pyrrolidine-1-carbonyl)phenylboronic acid (21.2 g, 96.7 mmol), and Pd(PPh3)4 (508 mg, 0.440 mmol) in toluene (200 mL) was added EtOH (40 mL) followed by Na2CO3 (70.0 mL, 140 mmol, 2 M aq solution) at room temperature. The resulting mixture was heated at 100° C. for 18 h. The reaction mixture was cooled to room temperature and the organic layer was separated. The aqueous layer was extracted with EtOAc (300 mL). The combined organic layers were washed with brine (500 mL), dried over MgSO4, filtered, and concentrated under reduced pressure to give the crude material that was combined with another batch of the crude material obtained from an additional run in the same reaction scale. The combined crude material was purified by silica gel flash column chromatography (CH2Cl2 to 1% MeOH in CH2Cl2). Preparation of (1E,4E)-2-amino-N-(2-amino-2-oxoethyl)-N-propyl-8-(4-(pyrrolidine-1-carbonyl)phenyl)-3H-benzo[b]azepine-4-carboxamide: A solution of the crude tert-butyl (1E,4E)-4-((2-amino-2-oxoethyl)(propyl)carbamoyl)-8-(4-(pyrrolidine-1-carbonyl)phenyl)-3H-benzo[b]azepin-2-ylcarbamate in anhydrous CH2Cl2 (15 mL) was bubbled with HCl (gas) for 4 h at 0° C. The resulting mixture was warmed to room temperature and stirred until the reaction was complete. To this mixture was added saturated NaHCO3 at 0° C. The aqueous layer was separated and extracted with CH2Cl2. The combined organic layers were dried over Na2SO4, filtered, and concentrated under reduced pressure to give the crude compound that was purified by silica gel flash column chromatography (MeOH:CH2Cl2=1:50).

1. temperatureThe reaction mixture was cooled to room temperature
2. customthe organic layer was separated
3. extractionThe aqueous layer was extracted with EtOAc (300 mL)
4. washThe combined organic layers were washed with brine (500 mL)
5. dry with materialdried over MgSO4
6. filtrationfiltered
7. concentrationconcentrated under reduced pressure
8. customto give the crude material that