Back
HuagongsheHuagongshe Chemistry Print Report · For research reference only
HRID 323014Generated: October 29, 2026

Potassium Carbonate → HCID 178463117, compound

https://huagongshe.com/reaction/323014

Reaction equation

Participants

RoleNameHCIDCharge
ReactantPotassium CarbonateHCID 11430—
ReactantThionyl ChlorideHCID 24386—
ReactantSodium BicarbonateHCID 516892—
Reactant2,3-dichloro-4-methylsulfonylbenzoic acidHCID 2786943—
ReactantHCID 178418331HCID 178418331—
CatalystAcetone CyanohydrinHCID 6406—
SolventWaterHCID 962—
SolventTolueneHCID 1140—
SolventSodium HydroxideHCID 14798—
ProductHCID 178463117HCID 178463117—

Reaction Conditions

Temperature90 °C

Reaction Steps

Thionyl chloride (3.5 g, 6.7 mmol) was added to a slurry of 1.3 g (4.8 mmol) of 2,3-dichloro-4-methylsulfonylbenzoic acid in 10 mL of toluene with stirring and the mixture was heated at reflux until a homogeneous solution was obtained, which required about 45 min. The volatile components of the mixture were removed by evaporation under reduced pressure and the residual acid chloride was taken up in 10 mL of dichloromethane. This solution was combined with a solution of 5.4 g (4.8 mmol) of 1-ethyl-5-hydroxypyrazole dissolved in 6.2 mL of 1 N aqueous sodium hydroxide solution diluted with 5 mL of water with stirring at ambient temperature. After 1 hour, the pH was adjusted to 8 by adding 1 M aqueous sodium bicarbonate. The phases present were separated and the aqueous phase was extracted with 3 mL of dichloromethane. The organic phase and extract were combined, washed with 5 mL of water, dried over sodium sulfate, filtered, and concentrated by evaporation under reduced pressure. The residue was taken up in 15 mL of anhydrous dioxane and 730 mg (5.3 mmol) of solid potassium carbonate was added. The mixture was heated at 90° C. with stirring for 2 hours and then another 100 mg of potassium carbonate and 2-3 drops of acetone cyanohydrin were added. Heating and stirring were continued for another 30 min and then the mixture was cooled and poured into 15 mL of water. The phases were separated and the aqueous phase was extracted with 2×5 mL of dichloromethane. The aqueous phase was then acidified with 6 N aqueous hydrochloric acid and the solids that formed were extracted with 2×5 mL of dichloromethane. All of the organic phases and extracts were combined, washed with 5 mL of water, dried over sodium sulfate, filtered, and concentrated by evaporation under reduced pressure. The residue, which amounted to 1.4 g (80 percent of theory), was recrystallized from aqueous ethanol to obtain the title compound as a white solid melting at 198-200° C.

Provenance & Evidence

DOI10.6084/m9.figshare.5104873.v1
Patent numberUS06211403B1
Source datasetuspto-grants-2001_04
ORD IDord-0e0b69f55bba4c06858a52030a3f61b0
Source noteuspto-grants-2001_04