HRID643202

反应详情

EQUATION

反应方程式

HRID 643202 的结构方程式

AUXILIARIES

试剂、催化剂与溶剂

1

CONDITIONS

反应条件

温度
50 °C

PROCEDURE

实验过程

trans-8-Methyl-6-nonenoic acid (1.00 g, 5.87 mmol), vanillyl alcohol (1.085 g, 7.04 mmol), and Novozym 435 (100 mg) were measured and placed in a flask (25 ml). The mixture in the flask free of a plug was heated with stirring in an oil bath at 50° C. for 16 hours. After 2 to 3 hours of stirring with heating, attachment of water on the wall of the upper part of the flask was observed. The reaction mixture was returned to room temperature, hexane (25 ml) was added, and Novozym 435 and precipitated vanillyl alcohol were removed by filtration. Hexane (25 ml) was added to the filtrate, and the mixture was washed with 5% aqueous citric acid solution (25 ml) and saturated brine (25 ml), and dried over anhydrous magnesium sulfate. Magnesium sulfate was removed by filtration, and the filtrate was concentrated under reduced pressure. Since production of polar impurity other than vanillyl alcohol was confirmed by TLC, the residue was dissolved in 50 ml of hexane and passed through a short column packed with 1.5 g of silica gel, and the silica gel was sufficiently washed away with a mixed solvent of hexane and ethyl acetate (volume ratio 10:1). The above-mentioned impurity was not detected in the eluent by TLC. The eluent was concentrated under reduced pressure to give capsiate (1.56 g, yield 86.6%) as a colorless oil. This capsiate contained a trace amount of trans-8-methyl-6-nonenoic acid.

WORKUP

后处理

  1. customplaced in a flask
  2. temperatureThe mixture in the flask free of a plug was heated
  3. stirringAfter 2 to 3 hours of stirring
  4. temperaturewith heating
  5. customwas returned to room temperature
  6. customNovozym 435 and precipitated vanillyl alcohol
  7. customwere removed by filtration
  8. additionHexane (25 ml) was added to the filtrate
  9. washthe mixture was washed with 5% aqueous citric acid solution (25 ml) and saturated brine (25 ml)
  10. dry with materialdried over anhydrous magnesium sulfate
  11. customMagnesium sulfate was removed by filtration
  12. concentrationthe filtrate was concentrated under reduced pressure
  13. dissolutionthe residue was dissolved in 50 ml of hexane
  14. washthe silica gel was sufficiently washed away with a mixed solvent of hexane and ethyl acetate (volume ratio 10:1)
  15. concentrationThe eluent was concentrated under reduced pressure