反应详情

温度

40 °C

Sodium hydroxide (98 g) was added to a solution of dimethyl formamide (2,800 mL) of ethyl 3-(4-hydroxyphenyl)propionate (400 g) and stirred at 40° C. for 30 minutes. Formation of a salt could be observed visually. 6-acetoxycyclohexane (515 g) was added and stirred at 80° C. for 7 hours. The reaction mixture was poured into water (2,000 mL) and, toluene was further added and stirred. After separation, the toluene layer was washed with 6N hydrochloric acid, an aqueous saturated solution of sodium carbonate and water successively and then dried over anhydrous magnesium sulfate. The solvent was distilled off from the toluene layer to obtain 709 g of concentrates. Sodium hydroxide (185 g) was dissolved in water (400 mL) to which ethanol (600 mL) and 709 g of the concentrates were added and heated and refluxed for 2 hours. The reaction mixture was concentrated under a reduced pressure by using an evaporator and the resultant concentrates were poured into 6N hydrochloric acid. The obtained slurry was filtered to obtain solids. They were recrystallized from ethanol to obtain (4-(6-hydroxyhexyloxy)phenyl)propionic acid (281 g). Melting point: 109° C. to 112° C.

1. stirringstirred at 80° C. for 7 hours
2. additionwas further added
3. stirringstirred
4. customAfter separation
5. washthe toluene layer was washed with 6N hydrochloric acid
6. dry with materialan aqueous saturated solution of sodium carbonate and water successively and then dried over anhydrous magnesium sulfate
7. distillationThe solvent was distilled off from the toluene layer
8. customto obtain 709 g of concentrates
9. additionwere added
10. temperatureheated
11. temperaturerefluxed for 2 hours
12. concentrationThe reaction mixture was concentrated under a reduced pressure
13. customan evaporator
14. additionthe resultant concentrates were poured into 6N hydrochloric acid
15. filtrationThe obtained slurry was filtered
16. customto obtain solids
17. customThey were recrystallized from ethanol