反应详情
EQUATION
反应方程式
REACTANTS
反应物
PRODUCTS
生成物
AUXILIARIES
试剂、催化剂与溶剂
CONDITIONS
反应条件
- 温度
- 5 °C
PROCEDURE
实验过程
To a 100-mL round-bottomed flask equipped with a magnetic stirrer, addition funnel and temperature controller, under nitrogen, was added 9-bromononanol (8.92 g, 40 mmol) and dichloromethane (30 mL). The resulting mixture was cooled to 5° C. and a solution of sodium bicarbonate (0.47 g, 5.6 mmol) and potassium bromide (0.48 g, 4 mmol) in water (10 mL) was added. 2,2,6,6-Tetramethyl-1-piperidinyloxy free radical (TEMPO) (63 mg, 0.4 mmol) was added and then a 10 to 13% bleach solution (27 mL) was added dropwise through the addition funnel at a rate such that the temperature was maintained at about 8° C. (+/−2° C.) with an ice cold bath (over about 40 min.). After addition of the bleach was complete, the mixture was stirred for 30 min. while maintaining the temperature at about 0° C. A solution of sodium bisulfite (1.54 g) in water (10 mL) was added and the resulting mixture was stirred at room temperature for 30 min. The layers of the mixture were then separated, and the milky aqueous layer was extracted with dichloromethane (1×20 mL). The combined dichloromethane layers were then washed with water (1×30 mL), dried (MgSO4), filtered and concentrated under reduced pressure to afford the title intermediate (8.3 g, 94% yield), which was used without further purification in the next step.
WORKUP
后处理
- customTo a 100-mL round-bottomed flask equipped with a magnetic stirrer, addition funnel
- addition2,2,6,6-Tetramethyl-1-piperidinyloxy free radical (TEMPO) (63 mg, 0.4 mmol) was added
- temperaturewas maintained at about 8° C. (+/−2° C.) with an ice cold bath (over about 40 min.)
- additionAfter addition of the bleach
- temperaturewhile maintaining the temperature at about 0° C
- stirringthe resulting mixture was stirred at room temperature for 30 min
- customThe layers of the mixture were then separated
- extractionthe milky aqueous layer was extracted with dichloromethane (1×20 mL)
- washThe combined dichloromethane layers were then washed with water (1×30 mL)
- dry with materialdried (MgSO4)
- filtrationfiltered
- concentrationconcentrated under reduced pressure