2-甲苯缩水甘油醚

1.09 at 68 °F (NTP, 1992) - Denser than water; will sink

Relative density (water = 1): 1.08

less than 1 mg/mL at 72 °F (NTP, 1992)

Solubility in water: none

200 °F (NTP, 1992)

200 °F

113 °C c.c.

498 °F at 760 mmHg (NTP, 1992)

at 0.533kPa: 109-111 °C

O-cresyl glycidyl ether is a clear light yellow liquid. (NTP, 1992)

Liquid

Clear light yellow liquid; [CAMEO]

COLOURLESS LIQUID.

Warning

H315: Causes skin irritation [Warning Skin corrosion/irritation]

P203, P261, P264, P272, P273, P280, P302+P352, P318, P321, P332+P317, P333+P317, P362+P364, P391, P405, and P501 (click each P-code to see the statement)

Warning

H315 (100%): Causes skin irritation [Warning Skin corrosion/irritation]

P203, P261, P264, P272, P273, P280, P302+P352, P318, P321, P332+P317, P333+P317, P362+P364, P391, P405, and P501 (click each P-code to see the statement)

Chemical: Oxirane, [(2-methylphenoxy)methyl]-

Oxirane, 2-[(2-methylphenoxy)methyl]- is listed on the EPA's Chemical Data Reporting (CDR) system. Manufacturers and importers of Oxirane, 2-[(2-methylphenoxy)methyl]- are required to report information about their production and use of this chemical to the EPA under the Toxic Substances Control Act (TSCA). (40 eCFR Part 711)

TP - indicates a substance that is the subject of a proposed TSCA section 4 test rule.

Status: Active Update: 05-04-2023 https://echa.europa.eu/registration-dossier/-/registered-dossier/14553

Oxirane, [(2-methylphenoxy)methyl]-: Does not have an individual approval but may be used under an appropriate group standard

This chemical is combustible. (NTP, 1992)

Combustible.

Skin Irrit. 2 (100%)

Skin irritation - category 2

Serious eye damage/eye irritation - Category 2B

Skin sensitization - Category 1A

Skin corrosion/irritation - Category 2

Muta. 2

Fires involving this material can be controlled with a dry chemical, carbon dioxide or Halon extinguisher. (NTP, 1992)

Use water spray, foam, powder, carbon dioxide.

Fresh air, rest.

Remove contaminated clothes. Rinse and then wash skin with water and soap.

First rinse with plenty of water for several minutes (remove contact lenses if easily possible), then refer for medical attention.

Rinse mouth.

EYES: First check the victim for contact lenses and remove if present. Flush victim's eyes with water or normal saline solution for 20 to 30 minutes while simultaneously calling a hospital or poison control center. Do not put any ointments, oils, or medication in the victim's eyes without specific instructions from a physician. IMMEDIATELY transport the victim after flushing eyes to a hospital even if no symptoms (such as redness or irritation) develop.

SMALL SPILLS AND LEAKAGE: If you spill this chemical, FIRST REMOVE ALL SOURCES OF IGNITION. Then, use absorbent paper to pick up all liquid spill material. Your contaminated clothing and absorbent paper should be sealed in a vapor-tight plastic bag for eventual disposal. Solvent wash all contaminated surfaces with ethanol followed by washing with a soap and water solution. Do not reenter the contaminated area until the Safety Officer (or other responsible person) has verified that the area has been properly cleaned.

Personal protection: particulate filter respirator adapted to the airborne concentration of the substance. Collect leaking and spilled liquid in covered containers as far as possible. Absorb remaining liquid in sand or inert absorbent. Then store and dispose of according to local regulations.

Cough. Sore throat.

Redness. Pain.

Redness.

Glycidyl ethers are used as reactive diluents in epoxy resins. [LaDou, p. 550]

Plastic Composites Manufacturing [Category: Industry]

Custom Compounding of Purchased Resins

Oxirane, 2-[(2-methylphenoxy)methyl]-: ACTIVE