StartseiteMCPWorkbenchSkills
StartseiteWorkbenchBenachrichtigungenMein Bereich
llms.txt · MCP-AnleitungDatenschutz · Nutzungsbedingungen · Supportv1.8.3
  1. Startseite
  2. /Reaktion

Sodium Carbonate → 4-Chloro-6-(2,5-dimethylphenyl)pyrimidine

HRID 338062
Drucken

Reaktionsgleichung

Reaktionsgleichung von HRID 338062
[Cl:1][C:2]1[CH:7]=[C:6](Cl)[N:5]=[CH:4][N:3]=1.[CH3:9][C:10]1[CH:15]=[CH:14][C:13]([CH3:16])=[CH:12][C:11]=1B(O)O.C(=O)([O-])[O-].[Na+].[Na+]>C1C=CC(P(C2C=CC=CC=2)C2C=CC=CC=2)=CC=1.C1C=CC(P(C2C=CC=CC=2)C2C=CC=CC=2)=CC=1.Cl[Pd]Cl.O.C(#N)C>[Cl:1][C:2]1[CH:7]=[C:6]([C:11]2[CH:12]=[C:13]([CH3:16])[CH:14]=[CH:15][C:10]=2[CH3:9])[N:5]=[CH:4][N:3]=1
KomponentenVersuchsvorschriftAufarbeitungQuellen und NachweiseNotizen zur Reaktion

Komponenten

8

Edukt 3

HCID 10340Sodium Carbonate2×HCID 709434,6-DichloropyrimidineHCID 2734347(2,5-Dimethylphenyl)boronic acid2×

Produkt 1

HCID 249022254-Chloro-6-(2,5-dimethylphenyl)pyrimidineAusbeute 64 %

Reagenzien, Katalysatoren, Lösungsmittel 4

HCID 6102075
Dichlorobis(triphenylphosphine)palladium
Katalysator
HCID 178418476HCID 178418476, VerbindungKatalysator
HCID 962WaterLösungsmittel2×
HCID 6342AcetonitrileLösungsmittel

Versuchsvorschrift

First, 4.97 g of 4,6-dichloropyrimidine, 5.02 g of 2,5-dimethylphenylboronic acid, 3.55 g of sodium carbonate, 0.29 g of bis(triphenylphosphine)palladium(II)dichloride (abbreviation: Pd(PPh3)2Cl2), 20 mL of water, and 20 mL of acetonitrile were put in a recovery flask equipped with a reflux pipe, and the air in the flask was replaced with argon. This reaction container was heated by being irradiated with microwaves (2.45 GHz, 100 W) for 30 minutes. Further, 1.25 g of 2,5-dimethylphenylboronic acid, 0.89 g of sodium carbonate, and 0.073 g of Pd(PPh3)2Cl2 were put in the flask, and the reaction container was heated again by being irradiated with microwaves (2.45 GHz, 100 W) for 30 minutes. Then, water was added to this solution and an organic layer was extracted with dichloromethane. The obtained organic layer was washed with water and saturated brine, and was dried with magnesium sulfate. After the drying, the solution was filtered. The solvent of this solution was distilled off, and then the obtained residue was purified by flash column chromatography using hexane and ethyl acetate in a ratio of 5:1 as a developing solvent, so that the target pyrimidine derivative was obtained (pale yellow oily substance, yield of 64%). A synthetic scheme of Step 1 is shown in (d-1) below.

Aufarbeitung

  1. customequipped with a reflux pipe
  2. temperatureThis reaction container was heated
  3. customby being irradiated with microwaves (2.45 GHz, 100 W) for 30 minutes
  4. temperaturethe reaction container was heated again
  5. customby being irradiated with microwaves (2.45 GHz, 100 W) for 30 minutes
  6. extractionan organic layer was extracted with dichloromethane
  7. washThe obtained organic layer was washed with water and saturated brine
  8. dry with materialwas dried with magnesium sulfate
  9. filtrationAfter the drying, the solution was filtered
  10. distillationThe solvent of this solution was distilled off
  11. customthe obtained residue was purified by flash column chromatography

Quellen und Nachweise

ORD-Eintrag
ord-a34f3acf090d4323bf6a3bfdf2adea03
Quelldatensatz
uspto-grants-2014_11
DOI
10.6084/m9.figshare.5104873.v1
Patentnummer
US08889858B2

Notizen zur Reaktion

Auf dieser SeiteKomponentenVersuchsvorschriftAufarbeitungQuellen und NachweiseNotizen zur Reaktion